KitchenAid KBZU122VSS Use & Care Guide - Page 21
Outdoor Side Burner Care
UPC - 883049184401
View all KitchenAid KBZU122VSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Manually lighting the side burner 1. Remove the outdoor side burner cover. 2. Remove the manual lighting extension (see following illustration) and attach a match to the split ring. 5. Do not lean over the side burner. Push in and turn the burner knob to LITE/HI for the burner closest to the lit match. The burner will light immediately. When burner is lit, turn knob to desired setting. 3. Strike the match to light it. 4. Guide the match to the burner you wish to light. 6. Repeat for each of the other burners as needed. 7. Remove match and replace manual lighting extension inside its holder. IMPORTANT: If burner does not light immediately, turn the burner knob to OFF and wait 5 minutes before relighting. If any burners do not light after attempting to manually light them, contact the KitchenAid Customer eXperience Center. See the "Assistance or Service" section. OUTDOOR SIDE BURNER CARE General Cleaning IMPORTANT: Before cleaning, make sure all controls are off and the side burner is cool. Always follow label instructions on cleaning products. For routine cleaning, wash with soap and water using a soft cloth or sponge. Rinse with clean water and dry at once with a soft, lint-free cloth to avoid spots and streaks. Do not use steel wool to clean the side burner, as it will scratch the surface. EXTERIOR The quality of this material resists most stains and pitting, providing that the surface is kept clean, polished and covered. ■ Apply stainless steel polish to all non-cooking areas before first use. Reapply after each cleaning to avoid permanent damage to surface. To avoid weather damage to finish, use stainless steel side burner cover. ■ Cleaning should always be followed by rinsing with clean warm water. STAINLESS STEEL IMPORTANT: To avoid damage to stainless steel surfaces, do not use soap-filled scouring pads, abrasive cleaners, Cooktop Polishing Creme, steel wool, gritty wash cloths or paper towels. ■ Wipe the surface completely dry with a soft cloth. ■ For tough spots or baked-on grease, use Kitchen and BBQ Grill Degreaser Part Number 31617, a commercial degreaser designed for stainless steel. See "Assistance or Service" section to order. To avoid damage to the finish, cleaners should not contain chlorine. INTERIOR Food spills should be cleaned as soon as entire side burner is cool. Spills may cause permanent discoloration. Cleaning Method: ■ Rub in direction of grain to avoid scratching or damaging the surface. Discoloration of stainless steel on these parts is to be expected, due to intense heat from the burners. Always rub in the direction of the grain. Cleaning should always be followed by rinsing with clean, warm water. Cleaning Method: ■ KitchenAid® Stainless Steel Cleaner and Polish Part Number 4396920 (not included) or KitchenAid® Stainless Steel Wipes Part Number 8212510 (not included): See "Assistance or Service" section to order. ■ Liquid detergent or all-purpose cleaner: ■ Rinse with clean water and dry with soft, lint-free cloth. ■ Vinegar to remove hard water spots. ■ Glass cleaner to remove fingerprints. ■ Liquid detergent or all-purpose cleaner. ■ Rinse with clean water and dry completely with a soft, lintfree cloth. ■ A heavy-duty scrub sponge can be used with mild cleaning products. ■ For small, difficult-to-clean areas, use Kitchen and BBQ Grill Degreaser Part Number 31617, a commercial degreaser designed for stainless steel. See "Assistance or Service" section to order. 21