KitchenAid KDTM704EBS Use & Care Guide - Page 12

CONTROLS AND CYCLE STATUS CONTROL PURPOSE COMMENTS To start or resume a wash cycle If the door is opened during a cycle for any reason or if the power is interrupted, the Start/Resume indicator flashes. The cycle will not resume until the Start/Resume button is pressed and the door is closed. NOTE: (for models with controls on top of the door) Push door firmly closed within 3 seconds of pressing Start/Resume. If the door is not closed within 3 seconds, the Start/Resume light will flash, an audible tone will be heard, and the cycle will not start. To reset any cycle or options during selection or to cancel a wash cycle after it's started. Press CANCEL/DRAIN to reset any control selections made. IMPORTANT: Your model may indicate that you press and hold the button for up to 3 seconds to initiate the cancel. The Cancel light will turn on and all other cycle and option lights will turn off when Cancel is active. See the "Canceling A Cycle" and "Changing A Cycle After Dishwasher Is Started" sections. (on some models) To turn the audible tones on or off. Press and hold the HI TEMP WASH button for 3 seconds to turn the audible tones on or off. Only audible tones for confirming button presses can be turned on/off. Important audible tones, such as indicating a cycle has been interrupted, cannot be deactivated. Dishwasher Feedback Section CONTROLS AND CYCLE STATUS CONTROL PURPOSE The Cycle Status A Indicator Light is used to follow the progress of the dishwasher cycle. It is located on the front of the door. COMMENTS The single indicator light on the front of the door panel (A) will remain blue during wash/rinse, red during dry, and white when complete. The Cycle Status Display is used to follow the progress of the dishwasher cycle, and to show other information. The Time Display is used for estimated cycle time and also for delay hours. Estimated cycle time is displayed in hours and minutes as you make cycle and option selections. After you start the dishwasher, the display counts down the time. After you press the Start/Resume button, the Time Display counts down seconds to close the door. If the door is not closed by the end of the countdown you will hear a series of beeps and the cycle will not start. When you select the Delay feature, the Time Display will give the number of hours followed by an "H". Canceling a Cycle 1. Open the door slightly to stop the cycle. Wait for the spraying action to stop before completely opening the door. 2. Press and hold CANCEL/DRAIN button once. The Cancel/ Drain light will light up. 3. Close the door and the dishwasher starts a drain cycle (if water remains in bottom of dishwasher). Let the dishwasher drain completely. The Cancel/Drain light turns off after 2 minutes. Changing a Cycle After Dishwasher Is Started 1. You can interrupt a cycle and restart your dishwasher from the beginning using the following procedure. 2. Open the door slightly to stop the cycle. Wait for the spraying action to stop, then open the door completely. 3. Check that detergent dispenser cover is still closed. If cover is open, you will need to refill the detergent dispenser before restarting your new cycle. 12