KitchenAid KESK901SBL Installation Instructions - Page 12
Verify Anti-Tip Bracket Location, Level Range
UPC - 883049026985
View all KitchenAid KESK901SBL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
3. Loosen (do not remove) the hex washer head screw and insert the neutral (white) wire under the screw clamp at the bottom of the center position terminal connector. 4. Insert the other 2 wires (lines 1 and 2) under the other 2 screw clamps. B A A. Insert wire under screw clamp. B. Hex washer head screw 5. Securely tighten the hex washer head screws to 35 lbs-in. (4.0 N-m) minimum torque to make proper electrical connection. 6. Tighten the locking ring of the conduit connector. 7. Replace the terminal block cover with screw. 3-wire connection: Direct Wire Use this method only if local codes permit connecting ground conductor to neutral supply wire. 1. Loosen (do not remove) the hex washer head screws and insert the neutral (white) wire under the screw clamp at the bottom of the center position terminal connector. D C E F B G A Verify Anti-Tip Bracket Location IMPORTANT: ■ On models with a warming drawer, the rear range foot must be viewed from the front and slightly to one side of the range. ■ On models with a storage drawer the drawer may be removed to better view the rear range foot. 1. To remove storage drawer: ■ Pull drawer straight out to the first stop. ■ Lift up the back of the drawer and pull out. 2. Making sure the anti-tip bracket is installed: ■ Look for the anti-tip bracket securely attached to floor. ■ Slide range back so rear range foot is under anti-tip bracket. 3. If installing the range in a mobile home, you must secure the range to the floor. Any method of securing the range is adequate as long as it conforms to the standards in the "Location Requirements" section. Level Range 1. Place rack in oven. Place level on rack and check levelness of range, first side to side; then front to back. A. Line 1 B. Ground-link C. Hex washer head screw D. Silver-colored terminal block screw E. Neutral (white) wire F. Line 2 G. UL listed conduit connector and power supply cable 2. Insert the other 2 wires (lines 1 and 2) under the other 2 screw clamps. B A A. Insert wire under screw clamp. B. Hex washer head screw 3. Securely tighten the hex washer head screws to 35 lbs-in. (4.0 N-m) minimum torque to make a proper electrical connection. 4. Tighten the locking ring of the conduit connector. 5. Replace the terminal block cover with screw. If range is not level, pull range forward until rear leveling leg is removed from the anti-tip bracket. Use pliers or wrench to adjust leveling legs up or down until range is level. Push range back into position. Check that rear leveling leg is engaged in anti-tip bracket. NOTE: Range must be level for satisfactory baking conditions. 2. Replace the storage drawer: ■ Fit the ends of the drawer rails into the guides in the cavity. ■ Slide the drawer closed. 12