Kodak Z1085IS Extended user guide - Page 55
Try one or more of the following, Adjust the camera Video Out setting NTSC or PAL - troubleshooting
UPC - 041771920296
View all Kodak Z1085IS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
Troubleshooting If Try one or more of the following In Review mode, a ■ Transfer the picture to the computer (see page 44), then format the blue or black card or internal memory (see page 33). screen is displayed Caution: Formatting a card deletes all pictures and videos, instead of a including protected files. picture. Shutter button does not work. ■ Turn on the camera (see page 2). ■ Wait until the Ready light stops blinking red before attempting to take another picture. ■ Transfer pictures to the computer (see page 44), delete pictures from the camera (page 15), switch image storage locations (see page 30), or insert a card with available memory (page 3). Slide show does ■ Adjust the camera Video Out setting (NTSC or PAL, see page 32). not run on external video device. ■ See the external device's user's guide. Picture is too light. ■ Move so there is at least 2 ft (0.6 m) between the camera and the subject. ■ Decrease Exposure Compensation (see page 38). Picture is not clear. ■ Clean the lens (see page 60). ■ Make sure your camera is not in Close-up mode. ■ Move so there is at least 2 ft (0.6 m) between the camera and the subject. ■ Press the shutter button halfway to focus and set exposure. When the ready light turns green, press the Shutter button completely down. ■ Place the camera on a flat, steady surface or use a tripod. Picture is too dark. ■ Turn on the flash (see page 9). ■ Move so there is no more than 11.8 ft (3.6 m) in wide angle and 6.9 ft (2.1 m) in telephoto between the camera and the subject. ■ Use Fill flash (see page 9) or change your position so light is not behind the subject. ■ Increase Exposure Compensation (see page 38). www.kodak.com/go/support 49