Konica Minolta bizhub PRESS 1250 SDD 2-Side Trimmer/Square Fold Unit User Guid - Page 12
Job Setup, 9 Center, Offset
View all Konica Minolta bizhub PRESS 1250 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Operator Manual STR0202 & SFM0704 DBCB-0512-0066-V005 STR0202 2-Side Trimmer & SFM0704 Square Fold Module 4. Operating the STR (continued) 4.3 Job Setup Proceed the following steps to set up the Job: 1) Determine the length of the booklet before trimming (= D 'Input Size') in mm. 2) Determine the length of the booklet after trimming (= A 'Finished Size') in mm. 3) Subtract 'A' from 'D' and spread the difference (= 'Total Waste') over 'B' and 'C'. If necessary, adjust the Trim Size symmetrical or asymmetrical (See Chapter 4.9 Center Offset). D 2- 35mm waste (top) B min. staple distance 40mm Trimmed size: Min. 200mm D Max. 320mm Finished Size (booklet size) min. staple distance 40mm 2- 35mm waste (bottom) A Bypass : D Min. 150mm Max. 320mm C As a rule, the following formula has to be correct in order to get the desired result: Finished Size (booklet after trimming) (A) Waste (front trim) (B) Waste (rear trim) (C) + Equals: Input Size (booklet before trimming) (D) or short: A + B + C = D V005 RI01 23-04-2012 DBCB-0512-0066-V005 - 12 -