Kyocera FS 1030D FS-1030D Operation Guide Rev-1.3 - Page 36
Connecting the Parallel Cable, Connecting the Power Cord, Connecting and Printing, OPERATION GUIDE
View all Kyocera FS 1030D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Connecting and Printing Connecting the Parallel Cable 1 Connect the printer cable (not included) to the Parallel Interface Connector. NOTE: Use a parallel printer cable that complies with IEEE 1284 standards. For optimum performance, install the printer close to the computer. The connection cable should be shielded and no longer than 3 meters (10 feet) long. 2 Close the clips on both sides to fix the connector in place. 3 Connect the other end of the printer cable to the computer's parallel interface connector. Connecting the Power Cord Install the printer close to an AC wall outlet. If an extension cord is used, the total length of the power cord plus extension should be 5 meters (16 feet) or less. NOTE: Ensure the printer's power switch is off. Only use the power cord supplied with the printer. 1 Connect the power cord to the Power Cord Connector at the rear of the printer. 2 Connect the other end of the power cord to a power outlet. 12 OPERATION GUIDE