Kyocera FS 1920 FS-1920 Operation Guide Rev 1.2 - Page 121
Auto Continue Setting
View all Kyocera FS 1920 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 121 highlights
Configuration Auto Continue Setting When Auto Continue is enabled, the printer will automatically print the next received data following a preset amount of time passes after any one of the following errors occurs: Memory overflow Press GO Print overrun Press GO KPDL error Press GO File not found Press GO Hard disk err Press GO RAM disk error Press GO MemoryCard err Press GO Duplex disabled Press GO If one of the above errors is caused by someone on a network where the printer is being shared, for example, data sent from another person will be printed after a preset amount of time. 1 Press the MENU key. 2 Press the or key repeatedly until Others > appears. Others > 3 Press the > key. 4 Press the or key repeatedly until Auto Continue > appears. >Auto Continue > Mode On 5 Press the ENTER key. A blinking question mark (?) appears. >Auto Continue Mode ? On 6 Select On or Off using the or key. 7 Press the ENTER key. 8 Press the MENU key. The message display returns to Ready. 1-105