Kyocera KM-C3225E Fax System (N) Operation Guide Rev-1.2 - Page 49
Canceling a Communication, Canceling a Memory Transmission (during scanning)
View all Kyocera KM-C3225E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
Fax Operation (Basic Use) Canceling a Communication You can cancel a communication even if it is already in progress. The methods for canceling a communication differ depending on whether that communication is a fax transmission or a fax reception, and whether that transmission was initiated using the Memory Transmission mode or the Direct Feed Transmission mode. The following contains explanations on the various methods used for canceling communications. Canceling a Memory Transmission (during scanning) If you want to cancel a Memory Transmission during scanning of the documents, simply press the Stop/Clear key. The document that is currently being scanned will be ejected and the touch panel will return to the initial mode settings. If there are any documents left in the Document Processor, remove them from the document table. Canceling a Memory Transmission (during transmission) If you want to cancel a Memory Transmission in which scanning all of the documents has been completed and the dialing or transmission operation has already begun, perform the following procedure. 1 Press the [Status] ([Act status]) key or for fax transmission. the Stop/Clear key in the bottom right of riginal & assign destination. the touch panel. The status of the communication currently in progress will appear in the message display.) Abbrev. Application TX setting Register Print Report Memory usage: .0% OCT-11-2005 16:00 Dest. check Re-dial On-hook Memory TX Status Auto RX 2 Press the [Stop] key. The touch panel will return to the initial mode settings. Check Status of Fax Status of Fax Port Doc #: 020. Dialing. Memory OCT-11 Print 03. Stop NOTE: If you attempt to cancel a transmission that is scheduled to multiple destinations (such as a Broadcast Transmission) and there were destinations still remaining to be transmitted to, a message will appear in the message display asking whether or not you want to continue the transmissions to the remaining destinations. To continue, press the [Yes] key. To stop the transmissions, press the [No] key. 2-13