LG 47WV30 Owners Manual - Page 19

REMOTE CONTROL 19 ENEGNLGISH Picture ID Picture ID is used to change the settings of a specific set (display) using a single IR receiver for multi-vision. The set receiving the IR signal communicates with another set via the RS232 connector. Each set is identified by a Set ID. If you assign the Picture ID using the remote control, only displays with the same Picture ID and Set ID can be controlled remotely. POWER MONITOR ENERGY INPUT IR Receiver ON OFF SAVING 1    .,! ABC DEF 2   RS232C GHI JKL   PQRS TUV  MNO Picture ID  WXYZ  Off  Close  1/a/A - * # CLEAR MARK ARC 3 PSM BRIGHT P A NESS G E 4 2X2 Multi-VisMioUTnE (Total Set ID: 4) Set IDs are assigned as shown in the picture. MENU AUTO S.MENU 1 Press the red ON button on the remote control to assign the PictureOKID. BACK TILE ID ON OFF EXIT 2 If you press the left/right buttons or press the ON button repeatedly, the Picture ID cycles through OFF and 0 to 4. Assign the ID you want. Picture ID Off POWER ◀ ▶ Close MONITOR ON OFF ENERGY INPUT SAVING    yyIf you assign.,!the SeAtBCID toDeEFach set with    multi-vision, GaHnI d theJKnL assigMNnO the Picture ID    using the red button on the remote control, the key comPmQRSand isTUVdisplaWyXYeZ d for the set  with the sa1m/a/eA Set ID-*#anCdLEPARicture ID. A set with different Set IMDARsK and Picture IDs cannot be controlled by IRARsCignals. yyFor Set mIDo, rseeienf"oArsmsaigtPinoSinMngonSBNeRhEIGtSoHSIwTDPAGEttoo assign the Product" on page 57. MUTE MENU AUTO S.MENU NOTE OK yyFor example, if the Picture ID is assigned to 2, the upper right display (Set ID: 2) can be controlled by IR signals. yyFor each sBeACt,KyouTIcLaE n chEXaITnge the ID settings forONthe POFIFCTURE, AUDIO, TIME, NETWORK and MY MEDIA menus or the hot keys on the remote control. yyIf you press the green OFF button for Picture IDs, the Picture IDs for all sets are turned off. If you then press any button on the remote control, all sets will start working again.