LG DLE2516 Owners Manual - Page 13
Confirming, Source, in Gas, Dryers, in Electric - door
View all LG DLE2516 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Prior to the first use of this appliance, use allpurpose cleaning products or a solution of detergent and water, with damp cloth to remove from the inside of the dryer drum/drying compartment any dust or dirt that may have accumulated inside the dryer. Plug-in your dryer after reviewing the fonowing parts on your dryer's Electrical Requirements. Effective dryer operation requires appropriate dryer airflow. The adequacy of the airflow can be measured by evaluating the static pressure. Static pressure in the exhaust duct can be measured with a manometer, placed on the exhaust duct approximately 2 ft. (60.9 cm) from the dryer. Static pressure in the exhaust duct should not exceed 518 inches (1.5 cm). The dryer should be checked while the dryer is running with no load. Measuring Static pressure Confirming Heat Source in Gas Dryers Close the door to the dryer drum/drying compartment and, alter completing all steps in this manual for proper installation of this dryer, start the dryer on a heat setting. Alter the dryer starts, the igniter will glow red and the main burner will ignite. Warning: If all air is not purged from the gas line, the gas igniter may go off before the gas and the main burner have ignited. If this happens, the igniter will re-attempt gas ignition after approximately two minutes. Confirming Heat Source in Electric Dryers Close the door to the dryer drum/drying compartment and, alter completing all steps in this manual for proper installation of this dryer, start the dryer on a heat setting. The exhaust air or the exhaust pipe should be warm alter the dryer has been operating for three minutes. Manometer Exhaust Duct MAXIMUM STATIC PRESSURE IN WATER COLUMN 518 inches (1.5 cm) 13