LG DLE2516 Owners Manual - Page 19
and connect it to center screw.
View all LG DLE2516 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Warning : Grounding through the neutral conductor is prohibited for (1) new branch-circuit installations, (2) mobile homes, (3) recreational vehicles, and (4) areas where local codes prohibit grounding through the neutral conductor. Failure to do so can result in fire or electrical shock. Prepare minimum 5 ft (1.52 m) of length in order for dryer to be replaced. First, strip 3 72 inches (8.9 cm) of outer sheath from end and strip 1 inch of insulation from each conductor. ¢ Then, put the hooked shape end of the wire under the screw of the terminal block (hooked end facing rightward) and pinch the hook together and tighten the screw securely. 1. Connect neutral wire (white) of power cord to center terminal block screw. 2. Connect red and black wires to the left and right terminal block screws. 3. Make sure that the strain relief screw is tightened. Be sure that all terminal block nuts are on tight and power cord is in right position. Center terminal block screw (silver) Neutral grounding wire (white) Neutral grounding wire (white) Strain relief ground connector • If your local codes or ordinances do not allow the use of a 3-wire connection, or you are installing your dryer in a mobile home, you must use a 4-wire connection. (N4-wirereceptacle EMA type 14-30R) r 4-prong plug _ Spade terminals with _ _pturnedends _Ground prong _Neutral prong do4-prongplug _ 3/4 in. (1.9 cm) pgng proved strain relief Ring terminals Center terminal block screw (silver) Neutral 9rounding wire (white) Neutral wire (white or center wire) Strain relief Green wire of power cord External ground connector 1. Connect neutral wire (white) of power cord to center terminal block screw. 2. Connect red and black wires to the left and right terminal block screws. 3. Connect ground wire (green) of power cord to external ground screw and move neutral ground wire of appliance and connect it to center screw. 4. Make sure that the strain relief screw is tightened. Be sure that all terminal block nuts are on tight and power cord is in right position. 19