LG DLEX9000V Owners Manual - English Spanish - Page 15

Installation Location Requirements, Clearances - review

Get LG DLEX9000V PDF manuals and user guides View all LG DLEX9000V manuals
Add to My Manuals
Save this manual to your list of manuals

Page 15 highlights

ENGLISH INSTALLATION 15 Installation Location Requirements WWARNING 3FBEBMMJOTUBMMBUJPOJOTUSVDUJPOTDPNQMFUFMZCFGPSFJOTUBMMJOHBOEPQFSBUJOHZPVSESZFSIt is important that you review this entire manual before installing and using your dryer. Detailed instructions concerning electrical connections, gas connections, and exhaust requirements are provided on the following pages. t"MPDBUJPOUIBUBMMPXTGPSQSPQFSFYIBVTUJOTUBMMBUJPO A gas dryer must be exhausted to the outdoors. See 7FOUJOHUIFESZFS. t"HSPVOEFEFMFDUSJDBMPVUMFUMPDBUFEXJUIJOGU (61 cm) of either side of the dryer. See $POOFDUJOH &MFDUSJD%SZFST t"TUVSEZGMPPSUPTVQQPSUUIFUPUBMESZFSXFJHIUPG lbs (90.7 kg). The combined weight of a companion appliance should also be considered. tNo other fuel-burning appliance can be installed in the same closet as a dryer. Do not operate your dryer at temperatures below 45°F (7°C). At lower temperatures, the dryer might not shut off at the end of an automatic cycle. This can result in longer drying times. The dryer must not be installed or stored in an area where it will be exposed to water and/or weather. Check code requirements. Some codes limit, or do not permit, installation of the dryer in garages, closets, mobile homes or sleeping quarters. Contact your local building inspector. NOTE t'MPPSNVTUCFMFWFM XJUIBNBYJNVNTMPQFPGJODI DN VOEFSFOUJSFESZFS$MPUIFTNBZOPUUVNCMF properly, and automatic sensor cycles may not operate correctly if dryer is not level. t'PSBHBSBHFJOTUBMMBUJPO ZPVXJMMOFFEUPQMBDFUIFESZFSBUMFBTUJODIFT DN BCPWFUIFGMPPS*GVTJOHB pedestal, you will need 18 inches (46 cm) to the bottom of the dryer. Clearances 14" max.* (35.6 cm) 18" min.* (45.7 cm) 48 in.2* (310 cm2) 24 in.2* (155 cm2) 1"* 333/8" 5"** (2.5 cm) (84.8 cm) (12.7 cm) 3"* (7.6 cm) 14" max.* (35.6 cm) 18" min.* (45.7 cm) 0" (0 cm) 407/8" (103.9 cm) 3"* (7.6 cm) 1" (2.5 cm) 29" (73.7 cm) 1" 1"* 333/8" 5"** (2.5 cm) (2.5 cm) (84.8 cm) (12.7 cm) 1"* (2.5 cm) 29" 1"* (73.7 cm) (2.5 cm) INSTALLATION SPACING FOR RECESSED AREA OR CLOSET INSTALLATION The following clearances are recommended for this dryer. Although this dryer has been tested for 1inch (2.5cm) clearance on the sides and rear, the recommended clearances should be considered for the following reasons: t"EEJUJPOBMDMFBSBODFTIPVMECFDPOTJEFSFEGPSFBTFPG installation and servicing. t"EEJUJPOBMDMFBSBODFTIPVMECFDPOTJEFSFEPOBMMTJEFT of the dryer to reduce noise transfer. t" EEJUJPOBMDMFBSBODFTNJHIUCFSFRVJSFEGPSXBMM EPPS and floor moldings. For closet installation, with a door, minimum ventilation openings in the top and bottom of the door are required. Louvered doors with equivalent ventilation openings are acceptable. t$PNQBOJPOBQQMJBODFDMFBSBODFTTIPVMEBMTPCF considered. NOTE There should be at least a little space around the dryer (or any other appliance) to eliminate the transfer of vibration from one to the other. With enough vibration, the appliances will make noise or touch each other causing paint damage and making even more noise.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
15
ENGLISH
Installation Location Requirements
WARNING
It is important that
you review this entire manual before installing and using your dryer. Detailed instructions concerning electrical
connections, gas connections, and exhaust requirements are provided on the following pages.
Do not operate your dryer at temperatures below 45°F (7°C). At lower temperatures, the dryer might not shut off
at the end of an automatic cycle. This can result in longer drying times. The dryer must not be installed or stored in
an area where it will be exposed to water and/or weather. Check code requirements. Some codes limit, or do not
permit, installation of the dryer in garages, closets, mobile homes or sleeping quarters. Contact your local building
inspector.
Clearances
INSTALLATION SPACING FOR RECESSED AREA OR CLOSET INSTALLATION
The following clearances are recommended for this dryer. Although this dryer has been tested for 1inch (2.5cm)
clearance on the sides and rear, the recommended clearances should be considered for the following reasons:
A gas dryer must be exhausted to the outdoors. See
.
(61 cm) of either side of the dryer. See
lbs (90.7 kg). The combined weight of a companion
appliance should also be considered.
No other fuel-burning appliance can be installed in the
same closet as a dryer.
installation and servicing.
and floor moldings.
of the dryer to reduce noise transfer.
For closet installation, with a door, minimum
ventilation openings in the top and bottom of the
door are required. Louvered doors with equivalent
ventilation openings are acceptable.
considered.
24 in.
2*
(155 cm
2
)
18" min.*
(45.7 cm)
1"*
(2.5 cm)
5"**
(12.7 cm)
48 in.
2*
(310 cm
2
)
14" max.*
(35.6 cm)
3"
*
(7.6 cm)
3"
*
(7.6 cm)
1"
(2.5 cm)
29"
(73.7 cm)
1"
(2.5 cm)
1"*
(2.5 cm)
5"**
(12.7 cm)
14" max.*
(35.6 cm)
18" min.*
(45.7 cm)
0"
(0 cm)
40
7/8
"
(103.9 cm)
1"*
(2.5 cm)
29"
(73.7 cm)
1"*
(2.5 cm)
33
3/8
"
(84.8 cm)
33
3/8
"
(84.8 cm)
NOTE
properly, and automatic sensor cycles may not operate correctly if dryer is not level.
pedestal, you will need 18 inches (46 cm) to the bottom of the dryer.
NOTE
There should be at least a little space around the dryer (or any other appliance) to eliminate the transfer of
vibration from one to the other. With enough vibration, the appliances will make noise or touch each other
causing paint damage and making even more noise.
INSTALLATION