LG GH22LP20 Owner's Manual (English) - Page 9

To Install as a Slave Drive To install the drive as a Slave, change the jumper setting on the rear panel to SL. DAIGUDITIAOL AANUADLIOOG DG R G L CS M S LA 39 40 INTERFACE POWER 1 2 +5 GND +12 Master drive (Booting hard disk) Master drive (Booting hard disk) Master drive (Other IDE drive) Slave drive (Super Multi DVD Rewriter) (Jumper set to Slave) - OR - Primary connector DAIGUDITIAOL AANUADLIOOG DG R G L CS M S LA 39 40 INTERFACE POWER 1 2 +5 GND +12 DAIGUDITIAOL AANUADLIOOG DG R G L CS M S LA 39 40 INTERFACE POWER 1 2 +5 GND +12 Slave drive (Super Multi DVD Rewriter) (Jumper set to Slave) Connecting the Power Connector Secondary connector Connect the power cable from the computer's power supply to the socket on the drive unit, fitting the connector firmly into the power in connector. If there is no spare power cable available in the computer, you will have to purchase a splitter cable of a suitable type. Beveled edge up NOTE : Improper connection may damage the drive and void the warranty. Generally, the power connector can only fit one way. Connecting the Interface Connector Connect the 80-pin IDE cable to the back of the Super Multi DVD Rewriter, making sure the coloured (red) stripe on the IDE cable is connected to pin 1 on the Super Multi DVD Rewriter (Pin 1 is closest to the Power Connector). Pin1 NOTE : Generally, the IDE connector is keyed and will only fit one way. Red-edge Replacing the Computer Cover When the installation of the drive unit is complete, replace the computer cover. 6