LG LP1210BXR Owner's Manual - Page 12

HOW TO USE USING THE CONTROLS AUTO CLEAN • To turn the AUTO CLEAN function on, press the AUTO CLEAN button while the air conditioner is running in COOL,DRY or ENERGY SAVER mode. This function can only be selected from the remote;it is not available from the control panel.It must be set each time you wish to run the AUTO CLEAN function. AUTO CLEAN is used to remove moisture from the heat exchange coils. This helps prevent the formation of mildew and odors. 1 To use AUTO CLEAN With the air conditioner running in COOL, DRY or ENERGY SAVER mode, press the AUTO CLEAN button. 2 "AUTO CLEAN" will be displayed in the LCD diplay. Press the POWER button to turn the air conditioner off.AUTO CLEAN will run the circulation and exhaust fans with the compressor off for a few minutes after the power is turned off. To cancel AUTO CLEAN, or to stop an AUTO CLEAN cycle in process, simply press the AUTO CLEAN button again. The AUTO CLEAN function will not operate if the air conditioner is already off. AUTO SWING AUTO SWING function can only be activated with the remote. When this function is on, the air discharge will oscillate to circulate air more evenly through the room. To turn this function off, simply press the AUTO SWING button with the remote again. With AUTO SWING off, you may also manually adjust the air discharge to the desired position. It will maintain this position until the air conditioner is turned off or AUTO SWING is activated. function can only be activated with the remote.When the displayed temperature is °C(of °F),you can press this button to swith to °F(or °C) . 12