LG LSC27990TT User Guide - Page 6
Door removal - parts
View all LG LSC27990TT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Installation Warning Remove lower cover and water feed tube Remove the freezer compartment door Door removal Electric Shock Hazard Disconnect electrical supply to refrigerator before installing. Failure to do so could result in death or serious injury. If your entrance door is too narrow for the refrigerator to pass through, remove the refrigerator door and pass the refrigerator laterally. Remove the lower cover by lifting upward, and then pull up the water feed tube while pressing the release ring shown in the figure to the right. Water Feed Tube Lower Cover NOTE • If a tube end is deformed or abraded, trim the part away. Disconnecting the tube under the door causes about 1/2 gallon (2 liters) water to flow out. Please put up a big container to prevent it. 1) Remove the hinge cover by loosening the screws. Disconnect all connections except the ground line. Upper Hinge 2) Remove the keeper by rotating it counter clockwise and then lifting the upper hinge up . Hinge Cover Keeper Connection Wires Ground Line Upper Hinge NOTE • When removing the upper hinge, be careful that the door does not fall forward . 3) Remove the freezer compartment door by lifting it upward. This time, the door should be lifted enough for the water feed tube to be completely pulled out. Lower hinge NOTE • After removing the door, take it into the kitchen where you are installing the refrigerator. Lay it down on a blanket and be careful to avoid damaging the water feed tube. Remove the refrigerator door 1) Loosen the hinge cover screws and remove the cover. Remove connection wire, if any, except for the ground line. Connection Wires 2) Remove keeper by rotating it clockwise ( ) and then remove the upper hinge by lifting it up ( ). Upper Hinge Keeper 3) Remove the refrigerator compartment door by lifting it up. 6 Lower Hinge