LG WD205CK Owners Manual - Page 28
Problem, Possible Cause, Solutions
View all LG WD205CK manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
28 TROUBLESHOOTING BEFORE CALLING FOR SERVICE (continued) Problem Washer will not operate Washer not filling properly Possible Cause Solutions Control panel has powered off due This is normal. Press the POWER button to turn the to inactivity. washer on. Washer is unplugged. Make sure cord is plugged securely into a working outlet. Water supply is turned off. Turn both hot and cold faucets fully on. Controls are not set properly. Make sure the cycle was set correctly, close the lid and press the START/PAUSE button. Lid or drawer is open The washer will not operate if the lid is open. Close the lid and drawer make sure that nothing is caught under the lid preventing it from closing completely. Circuit breaker/fuse is tripped/ blown. Check house circuit breakers/fuses. Replace fuses or reset breaker. The washer should be on a dedicated branch circuit. The washer will resume the cycle where it stopped once power is restored. Control needs to be reset. Press the POWER button, then re-select the desired cycle and press the START/PAUSE button. START/PAUSE was not pressed after a cycle was set. Press the POWER button then re-select the desired cycle and press the START/PAUSE button. The washer will shut off if the START/PAUSE button is not pressed within 4 minutes. Extremely low water pressure. Check another faucet in the house to make sure that household water pressure is adequate. Washer is too cold. If the washer has been exposed to temperatures below freezing for an extended period of time, allow it to warm up before pressing the POWER button. Otherwise, the display will not come on. Filter clogged. Make sure the inlet filters on the fill valves are not clogged. Refer to the filter cleaning instructions. Inlet hoses may be kinked. Check that inlet hoses are not kinked or clogged. Energy efficiency. This is a High Efficiency (HE) washer. As a result, the water level settings for this washer may be different than for conventional washers. Insufficient water supply. Make sure that both hot and cold water faucets are turned on all the way. lid and drawer are open. The washer will not operate if the lid is open. Close the lid and make sure that nothing is caught under the lid preventing it from closing completely. Hot and cold inlet hoses are reversed. Check inlet hose connections. Make sure the hot water supply is connected to the hot inlet valve, and the cold water supply is connected to the cold inlet valve. Water level is too low. This is a high efficiency washer. The water will not normally cover the clothes. The fill level is optimized for the wash motion to achieve the best wash performance.