LG WM3900HBA Owners Manual - Page 12
Unpacking and Removing Shipping Bolts
View all LG WM3900HBA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
12 INSTALLATION Unpacking and Removing Shipping Bolts Unpack all shipping materials from the washer for proper operation and inspect it for shipping damage. CAUTION ••Failure to remove shipping materials can cause excessive noise and vibration. 3 Install the hole caps. Locate the four hole caps included in the accessory pack and install them in the shipping bolt holes. Cap 1 Lift the washer off the foam base. After removing the carton and shipping material, lift the washer off the foam base. Make sure the plastic tub support comes off with the base and is not stuck to the bottom of the washer. If you must lay the washer down to remove the base packaging materials, always protect the side of the washer and lay it carefully on its side. Do not lay the washer on its front or back. NOTE ••Save the bolt assemblies for future use. To prevent damage to internal components, do not transport the washer without reinstalling the shipping bolts. ••Failure to remove shipping bolts and retainers may cause severe vibration and noise, which can lead to permanent damage to the washer. The cord is secured to the back of the washer with a shipping bolt to help prevent operation with shipping bolts in place. Foam tub support Carton base 2 Remove the bolt assemblies. Starting with the bottom two shipping bolts, use the wrench (included) to fully loosen all four shipping bolts by turning them counterclockwise. Remove the bolt assemblies by wiggling them slightly while pulling them out. Retainer Shipping bolt