Lenovo NetVista A40 Hardware Maintenance Manual (HMM) for NetVista 2271, 6840, - Page 44
Hard disk drive boot error, Error, FRU/Action, 2xx-2y, Corrupt BIOS, Test aborted by user
View all Lenovo NetVista A40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Error 2xx-2y A memory error was detected in DIMM/RIMM socket Y FRU/Action Replace the DIMM/RIMM in the socket identified by the last digit of the error code. Re-run the test. Corrupt BIOS If the same error code occurs again, replace the system board or where memory is on the processor card, replace the processor card. Reflash the BIOS. Information in BIOS is not as expected. Perform boot block recovery. Not able to find expected DMI information Replace the system board. from BIOS. Memory controller chipset vendor ID does not match expected value. Test aborted by user Restart test. Note: Y is the SIMM/DIMM/RIMM socket number. Use the System Board Layout section in the latest Hardware Maintenance Manual (HMM) to reference the memory sockets. Hard disk drive boot error A hard disk drive boot error (error codes 1962 and I999030X) can have the following causes. Error The start-up drive is not in the boot sequence in configuration. No operating system installed on the boot drive. The boot sector on the start-up drive is corrupted. The drive is defective. FRU/Action Check the configuration and ensure the start-up drive is in the boot sequence. Install an operating system on the boot drive. The drive must be formatted, do the following: 1. Attempt to access and recover (back-up) the failing hard disk drive. 2. Using the operating systems programs, format the hard disk drive. 3. Go to "Preparing the hard disk drive for use" on page 13. Replace the hard disk drive. 38 Hardware Maintenance Manual A40 Type 6840 A40P Type 6841 A40i Type 2271: IBM NetVista Computer