Home » Lenovo Manuals » Desktops » Lenovo ThinkCentre A52 » Manual Viewer

Lenovo ThinkCentre A52 User Manual - Page 46

Types 8099

View all Lenovo ThinkCentre A52 manuals

Add to My Manuals
Save this manual to your list of manuals

Page 46 highlights

Types 8099, 8116, 8155, 8156, 8157, 8158, 8159, 8160, 8215, 9210, and 9211 This section lists the physical specifications. Dimensions Width: 310 mm (12.2 in.) Height: 85 mm (3.35 in.) Depth: 358 mm (14.1 in.) Heat output (approximate) in British thermal units (Btu) per hour: Minimum configuration: 256 Btu/hr (75 watts) Maximum configuration: 768 Btu/hr (225 watts) Weight Minimum configuration as shipped: 7.3 kg (16 lbs) Maximum configuration: 8.5 kg (18.7 lbs) Environment Air temperature: Operating at 0 - 3000 ft (914.4 m): 10° to 35°C (50° to 95°F) Operating at 3000 ft - 7000 ft (2134 m): 10° to 32°C (50° to 89.6°F) Airflow Approximately 16 cubic feet (0.45 cubic meters) per minute Acoustical noise-emission values Note: In this computer, fan speed is controlled by temperature, configuration, and software. Actual noise-emission values might be different from the stated values depending on the number of fans and the speed of the fans. Average sound-pressure levels: Non-operating: 10° to 43°C (50° to 110°F) At operator position (0.5 meters): Humidity: Idle: 29 dBA Operating: 8% to 80% Operating: 34 dBA Non-operating: 8% to 80% At bystander position - 1 meter (3.3 ft): Transit: 8% to 90% Idle: 26 dBA Maximum altitude: 7000 ft (2133.6 m) Operating: 29 dBA Electrical input Input voltage: Low range: Declared (upper limit) sound-power levels: Idle: 4.0 bels Operating: 4.3 bels Minimum: 100 V ac Maximum: 127 V ac Input frequency: 50/60 Hz Voltage switch setting: 115 V ac High range: Minimum: 200 V ac Maximum: 240V ac Input frequency: 50/60 Hz Note: These levels were measured in controlled acoustical environments according to the procedures specified by the American National Standards Institute (ANSI) S12.10 and ISO 7779 and are reported in accordance with ISO 9296. Actual sound-pressure levels in a given location might exceed the average values stated because of room reflections and other nearby noise sources. The declared sound-power levels indicate an upper limit, below which a large number of computers will operate. Voltage switch setting: 230 V ac Input kilovolt-amperes (kVA) (approximate): Minimum configuration as shipped: 0.09 kVA Maximum configuration: 0.23 kVA 40 Hardware Maintenance Manual

Section	Page
Contents	5
Chapter 1. About this manual	7
Important Safety Information	7
Strategy for replacing FRUs for CTO, CMV, and GAV products	8
Product definition	8
FRU Identification for CTO, CMV, and GAV products	8
Using PEW	8
Using eSupport	9
Using the HMM	9
Important information about replacing RoHS compliant FRUs	9
Chapter 2. Safety information	11
General safety	11
Electrical safety	11
Safety inspection guide	13
Handling electrostatic discharge-sensitive devices	14
Grounding requirements	14
Safety notices (multi-lingual translations)	15
Chapter 3. General information	45
Additional information resources	45
Physical specifications	45
Types 8099, 8116, 8155, 8156, 8157, 8158, 8159, 8160, 8215, 9210, and 9211	46
Types 8110, 8112, 8113, 8114, 8115, 8153, 8166, 8167, 8168, 8169, and 8170	47
Types 8111, 8154, 8161, 8162, 8163, 8165, 8211, 8212, 8213, and 8214	48
Chapter 4. General Checkout	49
Problem determination tips	50
Chapter 5. Diagnostics using PC-Doctor for DOS	53
Starting PC-Doctor from the Rescue and Recovery workspace	53
Starting PC-Doctor from a diagnostic diskette or CD-ROM	54
Diagnostics program download	54
Navigating through the diagnostics programs	54
Running diagnostics tests	54
Test selection	55
Test results	55
Fixed disk advanced test (FDAT)	55
Quick and Full erase - hard drive	57
Viewing the test log	58
Chapter 6. Using the Setup Utility	59
Starting the Setup Utility program	59
Viewing and changing settings	59
Exiting from the Setup Utility program	59
Using passwords	59
Password considerations	60
User Password	60
Administrator Password	60
IDE Drive User Password	60
IDE Drive Master Password	60
Setting, changing, and deleting a password	61
Using Security Profile by Device	61
Selecting a startup device	62
Selecting a temporary startup device	62
Changing the startup device sequence	62
Advanced settings	62
Chapter 7. Symptom-to-FRU Index	63
Hard disk drive boot error	63
Power Supply Errors	63
Diagnostic error codes	65
Beep symptoms	86
No-beep symptoms	88
POST error codes	89
Miscellaneous error messages	92
Undetermined problems	94
Chapter 8. FRU lists	95
Machine Type 8099	96
Machine Type 8110	115
Machine Type 8111	131
Machine Type 8112	147
Machine Type 8113	161
Machine Type 8114	188
Machine Type 8115	205
Machine Type 8116	219
Machine Type 8153	234
Machine Type 8154	242
Machine Type 8155	250
Machine Type 8156	259
Machine Type 8157	267
Machine Type 8158	276
Machine Type 8159	286
Machine Type 8160	294
Machine Type 8161	303
Machine Type 8162	311
Machine Type 8163	319
Machine Type 8164	327
Machine Type 8165	335
Machine Type 8166	343
Machine Type 8167	349
Machine Type 8168	356
Machine Type 8169	367
Machine Type 8170	374
Machine Type 8211	381
Machine Type 8212	396
Machine Type 8213	423
Machine Type 8214	442
Machine Type 8215	458
Machine Type 9210	485
Machine Type 9211	504
Chapter 9. Additional Service Information	521
Security features	521
Hardware controlled Passwords	521
Operating system password	521
Vital product data	521
Management Information Format (MIF)	521
BIOS levels	522
Flash update procedures	522
Updating (flashing) BIOS from a diskette or CD-ROM	522
Updating (flashing) BIOS from your operating system	522
Recovering from a POST/BIOS update failure	523
Power management	524
Automatic configuration and power interface (ACPI) BIOS	524
Automatic Power-On features	524
Recovering software using the Rescue and Recovery program	525
Starting the Rescue and Recovery workspace	525
Appendix. Notices	527
Television output notice	528

Match case Limit results 1 per page

Types 8099, 8116, 8155, 8156, 8157, 8158, 8159, 8160, 8215,

9210, and 9211

This section lists the physical specifications.

Dimensions

Width: 310 mm (12.2 in.)

Height: 85 mm (3.35 in.)

Depth: 358 mm (14.1 in.)

Weight

Minimum configuration as shipped: 7.3 kg (16 lbs)

Maximum configuration: 8.5 kg (18.7 lbs)

Environment

Air temperature:

Operating at 0 - 3000 ft (914.4 m): 10° to 35°C (50°

to 95°F)

Operating at 3000 ft - 7000 ft (2134 m): 10° to 32°C

(50° to 89.6°F)

Non-operating: 10° to 43°C (50° to 110°F)

Humidity:

Operating: 8% to 80%

Non-operating: 8% to 80%

Transit: 8% to 90%

Maximum altitude: 7000 ft (2133.6 m)

Electrical input

Input voltage:

Low range:

Minimum: 100 V ac

Maximum: 127 V ac

Input frequency: 50/60 Hz

Voltage switch setting: 115 V ac

High range:

Minimum: 200 V ac

Maximum: 240V ac

Input frequency: 50/60 Hz

Voltage switch setting: 230 V ac

Input kilovolt-amperes (kVA) (approximate):

Minimum configuration as shipped: 0.09 kVA

Maximum configuration: 0.23 kVA

Heat output

(approximate) in British thermal units (Btu)

per hour:

Minimum configuration: 256 Btu/hr (75 watts)

Maximum configuration: 768 Btu/hr (225 watts)

Airflow

Approximately 16 cubic feet (0.45 cubic meters) per

minute

Acoustical noise-emission values

Note:

In this computer, fan speed is controlled by

temperature, configuration, and software. Actual

noise-emission values might be different from the stated

values depending on the number of fans and the speed

of the fans.

Average sound-pressure levels:

At operator position (0.5 meters):

Idle: 29 dBA

Operating: 34 dBA

At bystander position - 1 meter (3.3 ft):

Idle: 26 dBA

Operating: 29 dBA

Declared (upper limit) sound-power levels:

Idle: 4.0 bels

Operating: 4.3 bels

Note:

These levels were measured in controlled

acoustical environments according to the procedures

specified by the American National Standards Institute

(ANSI) S12.10 and ISO 7779 and are reported in

accordance with ISO 9296. Actual sound-pressure levels

in a given location might exceed the average values

stated because of room reflections and other nearby noise

sources. The declared sound-power levels indicate an

upper limit, below which a large number of computers

will operate.

Hardware Maintenance Manual