Lenovo ThinkCentre A52 User Manual - Page 67

Diagnostic Error Code 001-027-XXX System Configuration/Setup error 001-032-XXX System Device Controller failure 001-034-XXX System Device Buffer Allocation failure 001-035-XXX System Device Reset condition detected 001-036-XXX System Register error 001-038-XXX System Extension failure 001-039-XXX System DMI data structure error 001-040-XXX System IRQ failure 001-041-XXX System DMA failure 001-195-XXX System Test aborted by user 001-196-XXX System test halt, error threshold exceeded 001-197-XXX System test warning 001-198-XXX System test aborted FRU/Action 1. Run Setup 2. Flash the system. See "Flash update procedures" on page 516 3. System board System board 1. Reboot the system 2. Flash the system. See "Flash update procedures" on page 516 3. Run memory test 4. System board System board System board 1. Adapter card 2. System board 1. Flash the system. See "Flash update procedures" on page 516 2. System board 1. Power-off/on system and re-test 2. System board 1. Power-off/on system and re-test 2. System board Information only Re-start the test, if necessary 1. Press F3 to review the log file 2. Re-start the test to reset the log file 1. Make sure the component that is called out is connected and/or enabled. See Chapter 6, "Using the Setup Utility," on page 53 2. Re-run test 3. Replace the component that is called out in warning statement 4. Replace the component under test 1. If a component is called out, make sure it is connected and/or enabled. See Chapter 6, "Using the Setup Utility," on page 53 2. Flash the system and retest. See "Flash update procedures" on page 516 3. Go to "Undetermined problems" on page 88 Chapter 7. Symptom-to-FRU Index 61