Lenovo ThinkCentre M58 Hardware Maintenance Manual - Page 69
Beep symptoms, POST error codes, Power-On Self-Test
View all Lenovo ThinkCentre M58 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
Diagnostic Error Code 305-000-XXX Monitor DDC Test Passed 305-250-XXX Monitor DDC self test failure 415-000-XXXModem Test Passed 415-XXX-XXX Modem error FRU/Action No action 1. Run Setup to enable DDC 2. Cable 3. Monitor 4. Video card 5. System board No action Remove the Modem and re-test the system Beep symptoms Beep symptoms are tones or a series of tones separated by pauses (intervals without sound) during POST. The following tables describes beep symptoms. Beep Symptom Four sets of three beeps 4, 5, 6, or 7 beeps9, 10, or 11 beeps 8 beeps FRU/Action Reseat the memory modules. If the error persists, replace the memory modules one at a time until the failing module is determined. Before replacing the system board, remove any optional adapters (Express card, Modem card, Media reader) and retry. If the problem persists, replace the system board. Otherwise, reinstall the optional adapters one at a time until the failing adapter is determined. Replace the system board. POST error codes Each time you power-on the system, it performs a series of tests that check the operation of the system and some options. This series of tests is called the Power-On Self-Test, or POST. POST does the following operations. • Checks some basic system-board operations • Checks the memory operation • Starts the video operation • Verifies that the boot drive is working If the POST detects a problem, an error message appears on the screen. A single problem can cause several error messages to appear. When you correct the cause of the first error message, the other error messages probably will not appear on the screen the next time you turn on the system. Chapter 7. Symptom-to-FRU index 63