Lexmark 752e Setup Guide - Page 34

Installing a firmware card

Get Lexmark 752e - X MFP Color Laser PDF manuals and user guides View all Lexmark 752e manuals
Add to My Manuals
Save this manual to your list of manuals

Page 34 highlights

Installing a firmware card Note: Firmware and flash memory cards offered for other Lexmark printers cannot be used with your printer. Warning: Firmware and flash memory cards are easily damaged by static electricity. Touch something metal on the printer before you touch a card. Pins Follow the instructions in this section to install an optional firmware or flash memory card. Only one of each type of card is supported. 1 Remove the system board access cover (see Page 22). 2 Unpack the card. Avoid touching the metal pins on the bottom of the card. Save the packaging. 3 Holding the card by its sides, align the pins on the card with the holes on the system board. 4 Push the card firmly into place. The entire length of the connector on the card must touch the system board. Be careful not to damage the card connectors. What do I do now? Task Installing a hard disk Installing an option card Replacing the system board access cover Install memory, firmware, or option cards 25 Go to page... 26 28 30

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
25
Install memory, firmware, or option cards
Installing a firmware card
Follow the instructions in this section to
install an optional firmware or flash
memory card.
Note:
Firmware and flash memory cards offered for other
Lexmark printers cannot be used with your printer.
Only one of each type of card is
supported.
Warning:
Firmware and flash memory cards are easily
damaged by static electricity. Touch something metal on
the printer before you touch a card.
1
Remove the system board access
cover (see Page 22).
2
Unpack the card.
Avoid touching the metal pins on
the bottom of the card. Save the
packaging.
3
Holding the card by its sides, align
the pins on the card with the holes
on the system board.
4
Push the card firmly into place.
The entire length of the connector
on the card must touch the system
board.
Be careful not to damage the card
connectors.
Pins
What do I do now?
Task
Go to page…
Installing a hard disk
26
Installing an option card
28
Replacing the system board access cover
30