Lexmark C920 Menus and Messages - Page 14

Custom Types This menu selection is used to define a name for each custom paper type. You can assign names using a utility such as MarkVision or from the operator panel. Menu selection Custom Type N Purpose Specifies the type of paper associated with each Custom Type available in the Paper Type menu. Values Paper* Card Stock Transparency Glossy Labels Vinyl Labels Envelope The custom type media must be supported in the input source you designate in order to assign a user-defined name. Once the name is assigned, the name (truncated to 16 characters) will be displayed instead of Custom Type x. Universal Setup This menu selection is used to specify the height and width of the Universal Paper Size. By specifying the height and width for Universal Paper Size, the printer will use the Universal setting exactly like other paper sizes, including support for duplex and n-up. Menu selection Units of Measure Portrait Width Portrait Height Feed Direction Purpose Values Determines the unit of measure used to Inches enter the Universal Height and Width. Millimeters Inches is US default; Millimeters is international default. Sets the portrait width of the universal media. Note: If the value set exceeds the maximum width, the printer will use the maximum value allowed in inches or millimeters. 3 inches to 48 inches in 0.01 inch increments 76 mm to 1220 mm in 1 mm increments Shows either inches or mm from Units of Measure setting; 14 inches is the US default, and 365 mm is the international default. Sets the portrait height of the universal media. Note: If the value set exceeds the maximum height, the printer will use the maximum value allowed in inches or millimeters. 3 inches to 48 inches in 0.01 inch increments 76 mm to 1220 in 1 mm increments Shows either inches or mm from Units of Measure setting; 14 inches US default, 356 international default. Specifies the feed direction of the Universal Paper Size. Short Edge* Long Edge Long Edge is only shown if the longest edge is shorter than the Maximum Physical Width of the printer. Bin Setup Note: Bin Setup is only displayed when at least one optional output bin is installed. This menu selection is used to specify the output bin where you want your printed material to go to. Menu selection Output Bin Purpose Specifies the default bin for printed material. Values Standard Bin* Bin • If a user-defined name is available, it is displayed instead of Bin . • The name is truncated to 14 characters. • If two or more bins share the same name, the name only appears once in the Output Bin value list. Using printer menus 14