Lexmark Impact S301 User's Guide - Page 110
Notes, Software Already Installed, Install a printer, Additional Computer, Setting up a new, printer? - power supply cord
View all Lexmark Impact S301 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 110 highlights
MAKE SURE THAT THE PRINTER IS PLUGGED IN AND TURNED ON Check to see if the button is lit. If you have just turned on the printer, then you might need to disconnect the USB cable and reconnect it. MAKE SURE THAT THE USB PORT ON THE COMPUTER IS WORKING Test the USB port by connecting other devices to it. If you can successfully use other devices from the port, then the port is working. If the USB port on the computer is not working, then try using the other USB ports on the computer. MAKE SURE THAT THE USB CABLE IS WORKING Try using a different USB cable. If you are using a cable longer than 10 feet, then try using a shorter cable. MAKE SURE THAT YOU ARE USING THE CORRECT CD FOR YOUR PRINTER MODEL Compare the printer model on the CD to the printer model on the printer. The numbers should either match exactly or be within the same series. If you have any doubts, look for an updated version of the printer software on our Web site. For more information, see "Installing the printer software" in the User's Guide. You can access the User's Guide from the link at the bottom of the installation screen. RECONNECT THE POWER SUPPLY 1 Turn off the printer. 2 Unplug the power cord from the power outlet. 3 Remove the power supply from the back of the printer and then plug it back in. 4 Plug the power cord back into the power outlet. 5 Turn on the printer, and then resume the installation on your computer. TRY RUNNING THE INSTALLER AGAIN 1 Close the installer. 2 Remove the CD, and then restart the computer. 3 Insert the CD and then run the installer again. Notes: • When you get to the Software Already Installed screen, make sure you select Install a printer. • If you have already set up your printer, select Additional Computer when you get to the Setting up a new printer? screen to skip the hardware setup wizard. Troubleshooting 110