Lexmark MX722 PRESCRIBE Emulation P43.4 Technical Reference - Page 13

Lexmark Confidential until announced PRESCRIBE commands 13 FRPO: Firmware RePrOgram Kyocera printers support a large set of permanent defaults that can be set using the FRPO command. The PRESCRIBE emulation option supports a subset of the more significant settings. The FRPO INIT command is supported and affects only the settings in the following table, with the exception of the L parameters. These FRPO settings cannot be set differently per input port. Parameter A1,A2 A3,A4 A5,A6 A7,A8 C1 C3 L1,L2 L3,L4 L5,L6 L7,L8 N4 P1 Description Top margin Left margin Page length Page width Page orientation Default font Top‑edge limit Left‑edge limit Bottom‑edge limit Right‑edge limit Duplex binding Default emulation Factory default 0,0 0,0 15,0 9,0 0 0 0,20 0,20 10,60 8,10 0 6 P2 Carriage return 1 P3 Line feed 1 R3 Use FRPO edge limits and margins 0 U0 Line spacing 6 U1 Line spacing 0 U6 Country code 255 LA Character centering 1 (Center) LB Memorex font group 0 LC Use bitmaps if available 0 LE Paper source for LF/LG offsets 0 LF Top offset for LE source 0 LG Left offset for LE source 0 Notes N/A N/A Inches Inches N/A N/A N/A N/A N/A N/A N/A 0 = LinePrinter 1 = ProPrinter 6 = PCL N/A N/A PCL‑only setting Lines per inch (integer value) Lines per inch (fraction value) 255 = Use panel setting Lexmark‑only setting Lexmark‑only setting Lexmark‑only setting Lexmark‑only setting Lexmark‑only setting Lexmark‑only setting A1-A8: Margins FRPO margin settings are always acknowledged in ProPrinter and LinePrinter emulations. They are only acknowledged in PCL emulation if parameter R3 is set to 1.