Lexmark T612 Setup Guide (1.4 MB) - Page 20
Reattach Shield and Close Doors
UPC - 000073504283
View all Lexmark T612 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
6 Align the connection points on the card with the connector on the system board and push them firmly into the system board connector. 7 Insert the two screws saved from the metal plate (or the extra screws shipped with the card) into the holes as shown. 8 Tighten the screws to secure the card. Reattach Shield and Close Doors After you have installed card(s) on the printer system board, follow these steps to reattach the shield and close the doors. 1 Grasp the shield by the tabs and align the three keyholes on the shield with the top three screws. Holding the shield by the tabs, slide it down. Tighten all six screws. Tabs 2 Close the side door. 3 Close the upper and lower front doors. Note: If you have not completed the section "Placing the Printer" beginning on page 7, do so now. 18 Install Memory and Optional Cards