Lexmark T632dtn User's Reference - Page 271

Understanding the printer messages Message Queuing Jobs Ready Ready Hex Reattach Remove Paper Res Reduced Resetting Active Bin Resetting Maint Cnt Value Resetting the Printer What this message means What you can do The printer is sending one or more held jobs to print. The printer is ready to receive and process print jobs. The printer is in Hex Trace mode and is ready to receive and process print jobs. The specified device is either not fully connected to the printer or is experiencing a hardware failure. is one of the following: • Output bin x, where x is 1-3 • Bins x - y, where x is 1-5, 2-6, 6-10 • Env Feeder Wait for the message to clear. See also: Using the Print and Hold function Send a job to print. • Send a job to print. All data sent to the printer is printed in hexadecimal and character representation. Control strings are printed, not executed. • Turn the printer off and then on to exit Hex Trace mode and return to Ready status. • Reestablish communication by removing the specified device and reattaching it to the printer. • Press Go to clear the message and continue printing without using the device. • In the case of a hardware failure, turn the printer off and back on. If the error recurs, turn the printer off, remove the specified device, and call for service. See also: Contacting service The specified output bin, or bins, is full. The message would read as one of the following: • Remove Paper Standard Bin • Remove Paper Output Bin x, where x is the bin number • Remove Paper All Output Bins Remove the stack of paper from the specified bin(s) to clear the message. The printer is reducing the resolution of a page in the current job from 600 dots per inch (dpi) to 300 dpi to prevent a 38 Memory Full error. Res Reduced remains on the display while the job prints. Press Menu to open the Job Menu and cancel the current job. The printer is resetting to the active bin in a linked set of bins. Wait for the message to clear. The printer is resetting the counter that tracks wear on the fuser. Wait for the message to clear. The printer is resetting to the current default settings. Any active print jobs are canceled. Wait for the message to clear. See also: Using the operator panel to change printer settings 271