LiftMaster 87504-267 Users Guide - English French - Page 7
Programming, Remot e Cont rol, Wireless Keyless Entry, HomeLink®, To Erase the Memory
View all LiftMaster 87504-267 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Programming Remote Control Pre-programmed remote control included, no need to program the remote. To add or reprogram a remote control, follow the instructions below. Program Using the Garage Door Opener LEARN Button 1. Press and release the LEARN Button on the garage door opener. 2. Press and hold the button on the remote control that you wish to use. Release the button when the garage door opener lights blink or two clicks are heard. Program Using the Smart Control Panel® Select Menu > Program > Remote and follow the on screen prompts. Program Using the Multi-Function or Motion-Detecting Control Panel 1. Press the LEARN button on the door control to enter programming mode. 2. Press the LEARN button again, the command LED will flash once. 3. Press the button on the remote control that you wish to operate your garage door. Wireless Keyless Entry Refer to the instructions provided with your keyless entry OR go to LiftMaster.com to download instructions. HomeLink® If your vehicle is equipped with HomeLink®, a Compatibility Bridge™ (not included) may be necessary for certain vehicles. Visit bridge.liftmaster.com to find out if a Bridge is needed. To Erase the Memory Erase ALL Remote Controls and Keyless Entries Press and hold the LEARN button until the LED goes out (approximately 6 seconds). All remote controls and keyless entries are now erased. Erase ALL Devices (Including myQ® enabled accessories) 1. Press and hold the LEARN button until the LED goes out (approximately 6 seconds). 2. Immediately press and hold the LEARN button until the LED goes out. All codes are now erased. Erase the Wi-Fi Network from the Garage Door Opener Press and hold the adjustment button until 3 beeps are heard (approximately 6 seconds). Erase the Camera Settings - Models 84505R and 87504-267 Press and hold the reset button on the side of the camera for 10 seconds. The LED light will turn off, then flash red. You will need to set up your camera again after resetting it. LEARN Button Adjustment Button Navigation Buttons LEARN Button LEARN Button Command LED Command LED Smart Control Panel® Multi-Function Control Panel Motion-Detecting Control Panel 7