LiftMaster PPWR PPWR Passport Wiegand Reciever Manual - Page 1

APPLICATION The PPWR is a Wiegand compatible output radio receiver utilizing Security✚ 2.0™ technology. The PPWR is compatible with access system host controllers utilizing 26 Bit, 30 Bit, 31 Bit 34 Bit (even or odd), and 50 Bit Wiegand code formats. The receiver has two modes of operation: • Pass Through Mode - passes all received remote control signals to the access system host controller. • Advanced Mode - provides an additional layer of security in areas where other remote controls may be operating. The receiver only passes signals from a remote control with a previously programmed facility code. All other signals are blocked. The PPWR may be used with Security✚ 2.0™ Passport and Passport Lite remote controls. This receiver is compatible with HomeLink®. For programming or compatibility information visit www.homelink.com. The receiver is watertight according to IP44 specification. INSTALLATION 1. Select a convenient location near the access system host controller within "line of sight" of the intended transmitting location. NOTE: Do not mount the receiver in direct sunlight. Avoid mounting the receiver in a metal enclosure or near other wireless receiving or transmitting devices. 2. Mount the bracket to the desired surface with appropriate hardware (not provided)(Figure 1). 3. Remove the 4 #8 screws on the back of the receiver and remove the faceplate. Unplug the keypad connector from the control board. NOTE: Be careful not to damage the keypad cable while removing the faceplate. 4. Make wiring connections (Figure 2). Refer to your access system host owner's manual for more specific information. 5. Reconnect the keypad connector to the board (labeled J9). 6. Secure the faceplate with the 4 #8 screws previously removed. 7. Install the antenna (provided). NOTE: Use the optional 86LM or 86LMT antenna extension kit (see page 4) to mount the remote antenna as high and far from metallic objects as possible for best radio range. 8. Snap receiver onto the mounting bracket and secure with the #8 screws provided. 9. Tighten the watertight connector to secure and seal the wiring. PASSPORT WIEGAND RECEIVER MODEL PPWR To prevent possible SERIOUS INJURY or DEATH from electrocution: • Be sure power is NOT connected BEFORE installing the receiver. To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door: • ALWAYS keep remote controls out of reach of children. NEVER permit children to operate, or play with remote control transmitters. • Activate gate or door ONLY when it can be seen clearly, is properly adjusted, and there are no obstructions to door travel. • ALWAYS keep gate or garage door in sight until completely closed. NEVER permit anyone to cross path of moving gate or door. To prevent possible SERIOUS INJURY or DEATH, the use of CONSTANT OPERATION on residential openers is PROHIBITED. When a receiver is used to activate a commercial door opener, a reversing edge MUST be installed on the bottom of the door. Failure to install a reversing edge under these circumstances may result in SERIOUS INJURY or DEATH to persons trapped beneath the door. Figure 2 Figure 1 Antenna Connector Receiver Without Faceplate Backup Memory Module Mounting Bracket J9 Watertight Connector Keypad Connector 1 LED (from host) Data 1 (to host) Data 0 (to host) 12-24 VDC (+ Power Input) - Power Input Shield (to ground)