Linksys PCM200 User Guide - Page 17

Windows NT Installation and Setup for the EtherFast 10/100

Page 17 highlights

Linksys Instant EtherFast® Series 11. NT will copy the necessary network Note: For information and help on drivers to your PC. When the copying is choosing your bindings, services complete, you will see a list of installed and protocols, ask your network bindings. Change the bindings settings administrator, or check your Windows NT documentation. if needed and click Next. Click Next again. 12. Choose either Workgroup or Domain, depending on the type of network you're setting up. (Your NT user guide explains the difference between Workgroups and Domains.) Click Next. EtherFast® 10/100 CardBus PC Cards 13. Click Finish. When asked if you want to restart your computer, remove the Driver Disk and click Yes. 14. Once your PC has rebooted and you log on to the network, double-click the Network Neighborhood icon on your desktop. Ensure that you have access to the network. If you do, you card has been properly installed. • If you had previously installed any NT service packs, you must go back and re-install those service packs now. • If you need to install the TCP/IP protocol, refer to your system administrator or your Windows NT documentation. Linksys does not provide technical support for the configuration or troubleshooting of the TCP/IP protocol Windows NT Installation and Setup for the EtherFast 10/100 CardBus PC Card is complete. Do not continue with the next set of instructions. They are for NT users who already have their networking configured. Note: If you had previously installed any NT service packs, you must reinstall them. 28 29

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29

EtherFast
®
10/100 CardBus PC Cards
13. Click
Finish
. When asked if you want to restart your computer, remove
the Driver Disk and click
Yes
.
14. Once your PC has rebooted and you log on to the network, double-click
the
Network Neighborhood
icon on your desktop.
Ensure that you have
access to the network. If you do, you card has been properly installed.
• If you had previously installed any NT service packs, you must go back
and re-install those service packs now.
• If you need to install the TCP/IP protocol, refer to your system adminis-
trator or your Windows NT documentation. Linksys does not provide
technical support for the configuration or troubleshooting of the TCP/IP
protocol
Windows NT Installation and Setup for the EtherFast 10/100
CardBus PC Card is complete.
Do not continue with the next set of
instructions.They are for NT users who already have their
networking configured.
29
Linksys Instant EtherFast
®
Series
28
Note
: If you had
previously installed
any NT service
packs, you must re-
install them.
11. NT will copy the necessary network
drivers to your PC. When the copying is
complete, you will see a list of installed
bindings. Change the bindings settings
if needed and click
Next
. Click
Next
again.
12. Choose either
Workgroup
or
Domain
, depending on the type of network
you're setting up. (Your NT user guide explains the difference between
Workgroups and Domains.) Click
Next
.
Note:
For information and help on
choosing your bindings, services
and protocols, ask your network
administrator, or check your
Windows NT documentation
.