Lowrance Elite-12 Ti178 US Inland No Transducer Elite Ti2 Installation Manual - Page 34
Fuel remaining measurement, Fuel flow configuration, Uncon Reset Fuel Flow
View all Lowrance Elite-12 Ti178 US Inland No Transducer manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
Fuel remaining measurement The Fuel remaining measurement can be determined from fuel used by engine(s), or fuel level from tank sensors. Nominal fuel consumption is required to set the scale on the fuel economy gauge. This value should be determined from experience, over time. Alternatively the boat builder or designer may be able to give an approximate value to use. Ú Note: Fuel remaining measurement taken from level sensors while underway can get inaccurate readings due to vessel movement. Ú Note: Nominal fuel consumption setting should be determined taking into account typical vessel loads. That is, filled fuel and water tanks, stowed tender, supplies, etc. Fuel flow configuration After the number of engines is set, it is required to set which fuel flow sensor is connected to which engine. Under Device list on the Network page, view the Device Configuration dialog for each sensor, and set the Location to match the engine the device is connected to. Unconfigure - defaults the device which clears all user settings. Reset Fuel Flow - restores only the Fuel K-Value setting, if set in Calibrate. Only Navico devices can be reset. 34 Software setup | ELITE Ti² Installation Manual