MSI P7N SLI-FI User Guide - Page 58
BIOS Setup, 1T/2T Memory Timing, Adjust PCI-E Frequency MHz, CPU Voltage V, Memory Voltage V, VTT - problems motherboard
UPC - 816909045000
View all MSI P7N SLI-FI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
BIOS Setup 1T/2T Memory Timing This item controls the SDRAM command rate. Select [1T] makes SDRAM signal controller to run at 1T (T=clock cycles) rate. Selecting [2T] makes SDRAM signal controller run at 2T rate. Adjust PCI-E Frequency (MHz) This field allows you to select the PCI-E frequency (in MHz). CPU Voltage (V) This item allows you to increase the CPU voltage. M emory Voltage (V) Adjusting the memory voltage can increase the memory speed. VTT FSB Voltage (V) This item allows you to set the FSB VTT voltage. NB Voltage (V) Adjust the North Bridge chipset voltage. SB Voltage (V) Adjust the Sourth Bridge voltage. Spread Spectrum W hen the motherboard's clock generator pulses, the extreme values (spikes) of the pulses create EMI (Electromagnetic Interference). The Spread Spectrum function reduces the EMI generated by modulating the pulses so that the spikes of the pulses are reduced to flatter curves. If you do not have any EMI problem, leave the setting at Disabled for optimal system stability and performance. But if you are plagued by EMI, set to Enabled for EMI reduction. Remember to disable Spread Spectrum if you are overclocking because even a slight jitter can introduce a temporary boost in clock speed which may just cause your overclocked processor to lock up. Important 1. If you do not have any EMI problem, leave the setting at [Disabled] for optimal system stability and performance. But if you are plagued by EMI, select the value of Spread Spectrum for EMI reduction. 2. The greater the Spread Spectrum value is, the greater the EMI is reduced, and the system will become less stable. For the most suitable Spread Spectrum value, please consult your local EMI regulation. 3. Remember to disable Spread Spectrum if you are overclocking because even a slight jitter can introduce a temporary boost in clock speed which may just cause your overclocked processor to lock up. 3-21