Mackie SR244 VLZ Pro / SR324 VLZ Pro VLZ Pro Owner's Manual - Page 14
Patchbay Features, Mic, Line
View all Mackie SR244 VLZ Pro / SR324 VLZ Pro manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
PATCHBAY This is where everything gets plugged in: microphones, line-level instruments, effects devices, headphones and the ultimate destination(s): PA system, tape recorder, etc. MAIN OUTS (BAL OR UNBAL) 1 L AUX SENDS (BAL OR UNBAL) STEREO AUX RETURNS (BAL OR UNBAL) 4R L1 1 SUB OUTS (BAL OR UNBAL) SUB INSERTS (BAL OR UNBAL) 51 L 23 2 R 5R 2 L2 62 MONO R 21 L MONO R 20 INSERT 19 INSERT 18 INSERT 17 INSERT 16 INSERT 15 INSERT 14 INSERT 3 L 6R 3 L3 R (BAL OR UNBAL) L R L4 4 R MAIN INSERTS 120VAC 50/60 HZ 60W 1A/250V SLO BLO FUSE INSIDE CONTROL ROOM OUT POWER ON (MONO) PHANTOM ON CAUTION: TO REDUCE THE RISK OF FIRE, REPLACE WITH THE SAME TYPE FUSE AND RATING OFF OFF 73 84 24 L 22 L LINE IN (BAL OR UNBAL) MIC 20 XDR MIC PRE LINE IN (BAL OR UNBAL) MIC 19 XDR MIC PRE LINE IN (BAL OR UNBAL) MIC 18 XDR MIC PRE LINE IN (BAL OR UNBAL) MIC 17 XDR MIC PRE LINE IN (BAL OR UNBAL) MIC 16 XDR MIC PRE LINE IN (BAL OR UNBAL) MIC 15 XDR MIC PRE LINE IN (BAL OR UNBAL) MIC 14 XDR MIC PRE R R TAPE IN TAPE OUT PHONES 1 PHONES 2 TALK BACK MIC RIGHT MAIN OUT LEFT MAIN OUT OUTPUT LEVEL +6 MONO MAIN OUT MAIN BALANCED OUTPUTS PIN 2 = HOT PIN 3 = COLD OO 1. MIC The mono channels are equipped with Mackie's cutting-edge XDRTM microphone preamplifiers; providing up to 60dB of rugged, low-noise, crystal-clear, phantom-powered amplification. Their balanced circuitry rejects all manner of extraneous interference. Professional condenser, dynamic and ribbon mics will all sound excellent through these XLR inputs. The inputs will accept almost any kind of balanced mic that has a standard XLR-type male mic connector. SHIELD 2 HOT COLD 3 1 SHIELD 1 2. LINE IN The line inputs share circuitry (but not phantom power) with the mic preamps, and can be driven by balanced or unbalanced sources. These inputs can accept virtually any line-level signal, from -45dB up to +20dB. SLEEVE SLEEVE TIP TIP TIP SLEEVE 1/4" TS (Tip-Sleeve) unbalanced wiring: Tip = hot (+) Sleeve = shield RING SLEEVE SLEEVE RING TIP COLD 3 2 HOT 1 3 2 SHIELD COLD HOT XLR balanced wiring: Pin 1 = shield Pin 2 = hot (+) Pin 3 = cold (-) TIP RING TIP SLEEVE 1/4" TRS (Tip-Ring-Sleeve) balanced wiring: Tip = hot (+) Ring = cold (-) Sleeve = shield 14