Magnavox 51MP6100D User manual, English (US) - Page 7
Perating, Elevision, Emote, Ontrol - televisions
View all Magnavox 51MP6100D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Using the Remote Control OPERATING THE TELEVISION AND REMOTE CONTROL POWER TV SWAP VCR PIP CH ACC ACTIVE CONTROL FREEZE DN UP SOUND PICTUR E TELEVISION USING THE TV BUTTONS Should your remote control be lost or broken, you can still change some of the basic picture and sound settings with the buttons on the TV. Follow the steps below to familiarize yourself with the functions of the TV buttons. 1 Press POWER/STANDBY to turn the TV on (or off). Allow about 10 seconds for the TV to power on. 2 Press the VOLUME + or - buttons to decrease or increase the sound level. Press the VOLUME + and - buttons simultaneously to display the onscreen menu. After the menu appears, use these buttons to enter submenus and make selections or adjustments. (Use the CHANNEL buttons to move up and down in the menu or submenus.) Press both VOLUME buttons simultaneously to back out of the onscreen menus. 3 Press SOURCE SELECT to choose from among the signal inputs you have connected to the TV. 4 Press the CHANNEL buttons to select TV channels. Remote Sensor Window Power Standby Button H ELPFUL H INT You can press any of the buttons on the front of the TV to turn the TV on, but you must press thePower/Standby button to turn the set off. REMOTE CONTROL INSTALLING BATTERIES To load batteries into the remote, follow these steps. 1 Gently press the tab on the battery cover on the back of the remote and lift the battery cover off the remote. 2 Place the two "AA" size batteries in the remote's battery case. Ensure that the (+) and (-) ends of the batteries line up correctly with the (+) and (-) inside the case. 3 Press the battery cover back into place. Note: When operating the remote control, point the remote toward the remote sensor window on the TV. 7 B ATTERY U SAGE CAUTION To prevent battery leakage that may result in injury to you or damage to the remote control: • Install ALL batteries correctly, + and -, as marked on the unit. • Do not mix batteries (OLD and NEW or CARBON and ALKALINE, etc.) • Remove batteries when the remote control is not used for a long time. Do not take apart, heat, or put batteries in fire. H ELPFUL H INTS • Be sure to point the remote toward the sensor window on the TV. • Be within about 30 feet (10 meters) of the TV. • Avoid dropping the remote on hard surfaces. • Do not use harsh chemicals to clean the remote. Use only a soft, lightly moistened cloth.