Magnavox CC19C1MG99 User manual, English (US) - Page 44

44 SmartLock (cont'd) To change the access code, follow these steps. 1 Press the MENU button. 6 2,4 > SMARTLOCK REVIEW EXIT PRIM. SETUP VCR PROGRAM VCR SETUP PRESS B 2 Press the PLAY/v button or the STOP/w button to select SMARTLOCK. Then, press the F.FWD/B button. SMARTLOCK _ ___ 1 5 3 Enter Your Access Code 3 Use the Number buttons to enter your old access code. The default code is 0711. If you have never set up your personal access code, use 0711 now. After you enter the code, the SMARTLOCK menu will appear. SMARTLOCK X XX- EJECT MENU POWER STATUS/EXIT CLEAR 1 2 3 4 5 6 7 8 9 SLEEP/ WAKE UP ALT.CH 0 REC PAUSE /OTR /STILL PLAY REW F.FWD STOP CH. VOL. MUTE SPEED TRACKING MEMORY Enter Your Access Code 4 Press the PLAY/v button or the STOP/w button to select CHANGE CODE. Then, press the F.FWD/B button. SMARTLOCK BLOCK > CHANGE CODE SELECT KL CHOOSE B TO END PRESS EXIT 5 Use the Number buttons to enter your desired access code in the New Code space. Then, enter the same code in the Confirm Code space. Your new access code should be recorded. You will return to the SMARTLOCK menu. New Code _ ___ Confirm Code _ _ _ _ 6 Press the STATUS/EXIT button. Helpful Hints • To protect the privacy of the access code, an X will appear on the screen instead of the number you enter. • If a "Wrong Code..." message appears on the screen after you complete step 5, you entered the wrong numbers in the Confirm Code space. Repeat the steps on this page. • You cannot use the default code after you set up your personal access code. • If a power failure occurs, the default code, 0711, will be the active access code again. • If you connect the power cord to an AC outlet that is controlled by a wall switch, your personal access code will be erased every time you turn off the power at the wall switch. The default code will be the active code again.