Magnavox MSB4620/F7 Owners Manual English - Page 4

Disconnect the AC Power cord to shut Off the Unit when Trouble is found or not in Use. The AC Power cord shall remain readily operable and available. CAN ICES-3 (B)/NMB-3(B) ● This device complies with Industry Canada's applicable licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device. ● This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment and meets RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment has very low levels of RF energy that is deemed to comply without maximum permissive exposure evaluation (MPE). CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type. WARNING: Batteries (Battery pack or battery installed) shall not be exposed to excessive heat such as sunshine, fire or the like. Do not place the unit on the furniture that is capable of being tilted by a child and an adult leaning, pulling, standing or climbing on it. A falling unit can cause serious injury or even death. In order to avoid interruption of ventilation, this unit should not be placed in built-in equipment such as a book cabinet, rack, etc., and the vents of this unit should not be covered with anything such as a tablecloth, curtain, newspaper, etc. Make sure to leave a space of 4 inches (10cm) or more around this apparatus. Never use a gas duster on this unit. The gas trapped inside of this unit may cause ignition and explosion. This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. When installing this unit in a temperate environment, avoid a place with rapid temperature changes. This unit should not be used in a tropical environment as it has not been evaluated under such conditions. No objects should be placed directly on or under this unit, especially lighted candles or other flaming objects. Disposal of Used Batteries The batteries supplied do not contain the heavy metals mercury and cadmium, however in certain localities, disposing batteries with household waste is not permitted. Please ensure you dispose of batteries according to local regulations. Mounting Soundbar on a Wall ● The recommended screw (sold separately) allows the mounting of the Soundbar on the Wall. ● Funai is not liable for any accident, damage or injury due to any improper installation, lack of strength of installation or improper use. ● Drill screw holes into the wall. Depending on the wall material, use Molly Anchor inserts to make sure the screws will not fall out. Although the Soundbar weighs approximately 5.3 lb/2.4 kg, it is recommended that the wall be able to support 15. 9 lb/ 7.2 kg (three times the weight of the Soundbar) for extra safety. Recommended measurements are as follows: Wall thickness of 2"/5 cm or more, Screw diameter of 5/32"/4 mm and, Screw length of 1-3/16"/30 mm or more. ● Screw and Molly Anchor are sold separately and are not Included. Funai is not liable for these types kinds of accidents or injury noted below. ● Install two screws on a sturdy vertical wall. ● If installed onto a ceiling or slanted wall, the Soundbar and screws may fall which could result in a severe injury. ● Do not use screws that are longer or shorter than their specified length. If screws too long or short are used this may cause the Soundbar to fall. ● Do not fasten Screw's and Molly Anchor's with excessive force, this may damage the Wall causing the Soundbar to fall, leading to an injury. ● Do not mount the Soundbar onto screws while the Soundbar is Plugged In or turned On. It may result in an electrical shock injury. When Installing the Soundbar on a Wall, allow this much space. Top: 4"/10 cm Left and right sides: 4"/10 cm Bottom: 4"/10 cm Space between Mounting Screw and Wall: 9/64"- 5/32"/3.5 - 4mm EN - 4 -