Magnavox US2-MANT901 User manual, English (US) - Page 4
Assembly - tv antenna
View all Magnavox US2-MANT901 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
EN Assembly • Insert UHF Boom-A into UHF Boom-B and secure using 1-1/2˝ screw and lock washer. • Attach Reflector Arm Mounting Brackets to assembled UHF Boom (previous step) using two 1-1/2˝ screws and wing-nuts. Ensure that rotation arcs in Reflector Arm Mounting Brackets face toward UHF Boom elements. • Attach Corner Reflector Arms to Reflector Arm Mounting Brackets by sliding Reflector Arms between Mounting Brackets. Secure with 1-1/2˝ screw and wing-nuts. To fully secure Reflector Arms, snap into locking tabs and tighten screws. Assembly of VHF Portion • Rotate reflector element rods on VHF Boom-A and VHF Boom-B into place. NOTE: When rotating element rods, grasp close to pivot and relieve spring pressure on pivot bracket detents. Don't apply excess pressure to reflector element rods. • Attach one 46˝ Element to hole A in VHF Boom-B. • Attach one 50˝ Element to VHF Boom-B. Repeat each steps with second boom for VHF Boom-B. 6 Assembly EN • Insert VHF Boom-B into VHF Boom-A and secure using 1-1/2˝ screw and lock washers. Repeat steps for 2nd boom as well. • Attach tubing brace to rear of VHF Boom with 1-1/2˝ screws and wing-nuts. • Slide UHF Boom through center slot of VHF Boom support block until hole A of UHF Boom aligns with hole B of VHF Boom. Secure with 1-1/2˝ screw and wing-nut. • Attach phasing wire and lead-in wire to UHF antenna using 3/4˝ screws, washers, and wing-nuts. • Insert end caps at ends of all booms. Mast Assembly (Mast not included) • Assemble U-bolts to cross pieces. • Use saddle on center of boom. • Assemble U-bolt assemblies loosely to antenna. • Insert mast through U-bolts. • Tighten U-bolts securely. All U-bolts should be on one side of mast. • Attach mast standoff to mast. • Insert wire in standoff and tighten with pliers. • Power lines should be as far away as possible. • Assemble U-bolts in wall mounts with lock washers and nuts. • Secure mounts to wall with wood screws. • Separate mounts by at least two feet. • Insert mast with assembled antenna through both U-bolts. • Face antenna toward TV station. • Tighten U-bolts securely. • Wall mounts and chimney mounts are not included. 7