Makita AF601 AF601 Instruction Manual - Page 7

Nose adapter To prevent the surface of workpiece from being scratched or damaged, use the nose adapter. OPERATION CAUTION: Make sure all safety systems are in working order before operation. Selecting the operation mode CAUTION: Always make sure that the actuation mode selector is properly set to the position for the desired nailing mode before nailing. 1 2 ► 1 . Nose adapter 2. Contact element A spare nose adapter is stored in the place shown in the figure. 1 ► 1 . Spare nose adapter Connecting air hose ► 1 . Actuation mode selector Single sequential actuation mode: You can drive one nail by one sequential operation. Select this mode when driving a nail carefully and accurately. To choose this mode, set the actuation mode selector to 1 the position. Contact actuation mode: You can drive nails repetitively by placing the contact element with the trigger held. To choose this mode, set the actuation mode selector to the position. Single sequential actuation 1 2 Place the contact element against the workpiece and pull the trigger fully. After nailing, release the contact element, and then release the trigger. ► 1 . Air fitting 2. Air socket Slip the air socket of the air hose onto the air fitting on the nailer. Be sure that the air socket locks firmly into position when installed onto the air fitting. A hose coupling must be installed on or near the tool in such a way that the pressure reservoir will discharge at the time the air supply coupling is disconnected. 2 1 7 ENGLISH