Makita LS1216L Owners Manual - Page 22
Miter angle, Bevel angle
View all Makita LS1216L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
1. Miter angle Push the carriage toward the guide fence and tighten the locking screw clockwise and pull the lock lever toward yourself to secure the carriage. Turn the grip counterclockwise which secures the turn base. Turn the turn base so that the pointer points to 0° on the miter scale. Then turn the turn base slightly clockwise and counterclockwise to seat the turn base in the 0° miter notch. (Leave as it is if the pointer does not point to 0°.) Loosen the hex sockets bolts securing the guide fence using the socket wrench. Lower the handle fully and lock it in the lowered position by pushing in the stopper pin. Square the side of the blade with the face of the guide fence using a triangular rule, try-square, etc. Then securely tighten the hex socket bolts on the guide fence in the order from the right side. 1. Triangular rule 1 009509 Make sure that the pointer points to 0° on the miter scale. If the pointer does not point to 0°, loosen the screw which secures the pointer and adjust the pointer so that it will point to 0°. 1. Screw 1 2. Pointer 3. Miter scale 009525 2 3 2. Bevel angle Push the latch lever forward fully to release the positive stops. (1) 0° bevel angle 1. Pointer 1 2. Lever 3. Bevel scale 2 plate 3 009512 Push the carriage toward the guide fence and tighten the locking screw clockwise and pull the lock lever toward yourself to secure the carriage. Lower the handle fully and lock it in the lowered position by pushing in the stopper pin. Loosen the lever at the rear of the tool. Turn the hex socket bolt on the right side of the arm holder two or three revolutions counterclockwise to tilt the blade to the right. 1. 0 ゚ Angle adjusting bolt 3 2. Lever 3. Latch lever 2 009511 1 Carefully square the side of the blade with the top surface of the turn base using the triangular rule, try-square, etc. by turning the hex socket bolt on the right side of the arm holder clockwise. Then tighten the lever securely. 1. Triangular rule 1 2. Saw blade 3. Top surface of 2 turn base 3 001819 22