Makita LS1221 Owners Manual - Page 14
Sub-fence, Vertical vise - parts
View all Makita LS1221 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
1 1. Support 2. Turn base 1 001549 2 CAUTION: • When cutting long workpieces, use supports that are as high as the top surface level of the turn base. Do not rely solely on the vertical vise and/or horizontal vise to secure the workpiece. Thin material tends to sag. Support workpiece over its entire length to avoid blade pinch and possible KICKBACK. 001842 Sub-fence This tool is equipped with the sub-fence. It should be positioned as shown in the figure. 1. Sub-fence 1 1. Sub-fence 1 2 3 4 5 1. Vise arm 2. Vise rod 3. Guide fence 4. Holder 5. Holder assembly 6. Vise knob 7. Screw 14 001843 CAUTION: • When performing left bevel cuts, flip the fence over to the left position as shown in the figure. Otherwise, it will contact the blade or a part of the tool, causing possible serious injury to the operator. 001796 6 7 Vertical vise The vertical vise can be installed in two positions on either the left or right side of the guide fence or the holder assembly (optional accessory). Insert the vise rod into the hole in the guide fence or the holder assembly and tighten the screw to secure the vise rod. Position the vise arm according to the thickness and shape of the workpiece and secure the vise arm by tightening the screw. If the screw to secure the vise arm contacts the guide fence, install the screw on the opposite side of vise arm. Make sure that no part of the tool contacts the vise when lowering the handle all the way. If some part contacts the vise, re-position the vise.