Makita XDT09M Instruction Manual - Page 6
Changing the impact force
View all Makita XDT09M manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
NOTE: • The tool automatically stops if you keep pulling the switch trigger for about 180 seconds. Electric brake This tool is equipped with an electric brake. If the tool consistently fails to quickly stop after the switch trigger is released, have the tool serviced at a Makita service center. Lighting up the front lamp CAUTION: • Do not look in the light or see the source of light directly. 1. Lamp 1 014965 1. Button Reversing switch action 1 1 1. Reversing switch lever A B 014967 This tool has a reversing switch to change the direction of rotation. Depress the reversing switch lever from the A side for clockwise rotation or from the B side for counterclockwise rotation. When the reversing switch lever is in the neutral position, the switch trigger cannot be pulled. CAUTION: • Always check the direction of rotation before operation. • Use the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. • When not operating the tool, always set the reversing switch lever to the neutral position. Changing the impact force 1 1 2 014966 To turn on the lamp status, press the button for few seconds. To turn off the lamp status, press the button 6 for few seconds again. 3 With the lamp status ON, pull the switch trigger to turn on the lamp. To turn off, release it. The lamp goes out approximately 10 seconds after releasing the switch trigger. With the lamp status OFF, the lamp will not turn on even 4 if the trigger is pulled. NOTE: • To confirm the lamp status, pull the trigger. When the lamp lights up by pulling the switch trigger, the lamp status is ON. When the lamp does not come on, the lamp status is OFF. • While pulling the switch trigger, the lamp status cannot be changed. • For approximately 10 seconds after releasing the switch trigger, the lamp status can be changed. 5 1. Changed in four steps 2. Hard 3. Medium 4. Soft 5. T mode 6. Button 012609 6