Makita XDT09M Instruction Manual - Page 8

LED indicator status Remaining battery capacity 1. Bit 2. Sleeve About 50% or more About 20% - 50% About less than 20% 012273 NOTE: • When the LED display goes off, the tool is turned off to save the battery power. To check the remaining battery capacity, slightly pull the switch trigger. • The LED display goes off approximately one minute after releasing the switch trigger. • When the tool is overheated, the light blinks for one minute, and then the LED display goes off. In this case, cool down the tool before operating again. • When the LED display lights up and the tool stops even with a recharged battery cartridge, cool down the tool fully. If the status will not change, stop using and have the tool repaired by a Makita local service center. ASSEMBLY CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. Installing or removing driver bit or socket bit 1 2 011406 To remove the bit, pull the sleeve in the direction of the arrow and pull the bit out. NOTE: • If the bit is not inserted deep enough into the sleeve, the sleeve will not return to its original position and the bit will not be secured. In this case, try re-inserting the bit according to the instructions above. • When it is difficult to insert the bit, pull the sleeve and insert it into the sleeve as far as it will go. • After inserting the bit, make sure that it is firmly secured. If it comes out, do not use it. Hook 1. Groove 2. Hook 1 3. Screw 2 3 014996 The hook is convenient for temporarily hanging the tool. This can be installed on either side of the tool. To install the hook, insert it into a groove in the tool housing on either side and then secure it with a screw. To remove, loosen the screw and then take it out. OPERATION 12 mm (15/32") 9 mm (3/8") 001266 Use only bits that has inserting portion shown in the figure. To install the bit, insert the bit into the sleeve as far as it will go. 014978 The proper fastening torque may differ depending upon the kind or size of the screw/bolt, the material of the workpiece to be fastened, etc. The relation between fastening torque and fastening time is shown in the figures. 8