Makita XDT12T XDT12 Instruction Manual - Page 9
Assembly
View all Makita XDT12T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Impact force grade displayed on panel A mode Maximum blows 3,800 min-1 (/min) Purpose Example of application Tightening screws with better control. Tightening long screws. NOTE: T mode and A mode is available only when the tool rotates clockwise. When rotating counterclockwise in T mode and A mode, the impact force and speed are the same as max mode. NOTE: When all lamps on the switch panel go out, the tool is turned off to save the battery power. The impact force grade can be checked by pulling the switch trigger to the extent that the tool does not operate. NOTE: While pulling the switch trigger, the impact force grade cannot be changed. ASSEMBLY CAUTION: Always be sure that the tool is 1 switched off and the battery cartridge is removed before carrying out any work on the tool. Installing or removing driver bit/ socket bit 2 12 mm (15/32") 9 mm (3/8") Use only the driver bit/socket bit shown in the figure. Do not use any other driver bit/socket bit. 1 ► 1 . Driver bit 2. Sleeve To remove the driver bit, pull the sleeve in the direction of the arrow and pull the driver bit out. NOTE: If the driver bit is not inserted deep enough into the sleeve, the sleeve will not return to its original position and the driver bit will not be secured. In this case, try re-inserting the bit according to the instructions above. NOTE: When it is difficult to insert the driver bit, pull the sleeve and insert it into the sleeve as far as it will go. NOTE: After inserting the driver bit, make sure that it is firmly secured. If it comes out, do not use it. Installing hook 3 1 2 ► 1 . Driver bit 2. Sleeve To install the driver bit, insert it into the sleeve as far as it will go. 2 ► 1 . Groove 2. Hook 3. Screw 9 ENGLISH