Makita XGC01Z Makita XGC01Z Instruction Manual - Page 7

A B C 015611 Attach the holder joint firmly along the tool, and fix them with screws tightly. To remove the holder joint, follow above procedure in reverse. NOTE: • There are three types of holders (optional accessory), short holder (300ml(18.3cu.in)), long holder (600ml(36.6cu.in)), and big holder (800ml(48.8cu.in)). Use appropriate holder joint accordingly. Installing rod and piston For short holder (300ml(18.3cu.in)) 013611 For big holder (800ml(48.8cu.in)) D 015612 D A 015608 For long holder (600ml(36.6cu.in)) A B C 013612 015607 Insert the rod into the slit of the tool. Attach the piston and tighten it with a screw. To remove the rod and piston, follow the installation procedure in reverse. NOTICE: • The teeth on the rod must point down. • There are four types of pistons. Piston A and D for cartridges. Piston B for film type packs. Piston C for direct filling. • Choose appropriate piston in accordance with the type of caulking material container. Improper piston may cause leakage or tool breakage. • There are three types of rods. The rod for the short holder (300ml(18.3cu.in)), rod for long holder (600ml(36.6cu.in)), and rod for big holder (800ml(48.8cu.in)). Use appropriate rod in accordance with holder type. • Always keep the rod and piston clean. Adhering caulk may damage the tool. 7