Makita XGC01Z Makita XGC01Z Instruction Manual - Page 9
Operation, Maintenance
View all Makita XGC01Z manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
OPERATION 013555 Cut off the tip of the film type pack. Insert the film type pack into the holder. 1. Rubber ring 2. Nozzle 3. Holder cap 1 3 013569 Attach the rubber ring, the nozzle and the holder cap. Make sure holder cap is tightened firmly. Push the rod gently until the piston touches the bottom of the film type pack. NOTE: • Always check the film type pack for puncture or damage before installing. Do not use damaged pack, otherwise the tool may be damaged. Direct filling NOTICE: • Make sure the piston C is attached to the rod. Do not use other type of piston for direct filling. • Direct filling can only be performed with the long holder (600ml(36.6cu.in)). Remove the holder cap, the nozzle and the rubber ring from the holder. Make sure the rod handle is placed at the most front position. Dip the mouth of the holder into the caulking material. Pull the rod handle slowly until required amount of caulking material is filled in the holder. Attach the rubber ring, the nozzle and the holder cap. Make sure holder cap is tightened firmly. NOTICE: • Clean the holder with appropriate solvent after every day's work. Otherwise adhered caulking material may cause tool breakage. CAUTION: • Do not touch the rod during operation. Otherwise your finger may be pinched between the rod and the housing of the tool. • Always wear goggles during operation. NOTICE: • Do not cover vents, or it may cause overheating and damage to the tool. • If you can not pull out the rod, turn the speed adjusting dial to 1, and pull the switch trigger for a moment, and try to pull the rod out after the motor stopped. If the rod is still clogged, perform the same action until the rod is able to move. Cut off the tip of the nozzle suitable for individual operation. Be careful how much you cut the nozzle. The diameter of the nozzle affects the amount of caulking material dispensed. Pull the trigger to dispense caulking material. The amount of the caulking material dispensed is determined by the trigger, the speed adjusting dial, the diameter of the nozzle opening, caulking material type, and temperature. It is recommended that the speed adjusting dial is set to '1' and pull the trigger slowly at the first time to test how much amount of caulking material is dispensed. When the rod reaches front end, the motor starts idling. Replace the caulking material when it happens. NOTE: If the caulking material is not dispensed, check the following items: • Nozzle tip is not cut adequately. Cut the nozzle tip suitable for individual operation. • Hardened material gets clogged in the nozzle. Remove the hardened material. • The cartridge is damaged. Replace the cartridge. • Caulking material is stiff. Warm the material until it becomes soft. • The wrong piston is used. Use appropriate piston. MAINTENANCE CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before attempting to perform inspection or maintenance except for the following troubleshooting related to the light. • Never use gasoline, benzine, thinner, alcohol or the like. Discoloration, deformation or cracks may result. 9