Makita XT286SM1 XRU11 Instruction Manual - Page 11
Installing nylon cutting head, Adjusting the handle/hanger, position
View all Makita XT286SM1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
1 2 3 1 ► 1 . Wire guard NOTE: Do not expand the wire guard outward too much. Otherwise it may break. When wire guard is not in use, lift it for the idle position. Installing nylon cutting head Optional accessory CAUTION: If the nylon cutting head acciden- tally impacts a rock or hard object during operation, stop the tool and inspect for any damage. If the nylon cutting head is damaged, replace it immediately. Use of a damaged cutting tool could result in serious personal injury. CAUTION: Make sure to remove the hex wrench after installation. NOTICE: Be sure to use genuine Makita nylon cutting head. 4 ► 1 . Nylon cutting head 2. Metal guard 3. Spindle 4. Hex wrench 1. Turn the tool upside down so that you can replace the cutting tool easily. 2. Insert the hex wrench through the hole on the motor housing and rotate the spindle until the spindle is locked. 3. Place the nylon cutting head onto the threaded spindle directly and tighten it by turning it counterclockwise. 4. Remove the hex wrench. To remove the nylon cutting head, turn it clockwise while holding the receive washer with the hex wrench. Adjusting the handle/hanger position Adjust the handle and hanger position to obtain confortable handling of the tool. Loosen the hex socket head bolts on the handle. Move the handle to a comfortable working position and then tighten the bolts. 1 2 ► 1 . Hex socket head bolt 2. Handle Loosen the hex socket head bolt on the hanger. Move the hanger to a comfortable working position and then tighten the bolt. 11 ENGLISH