Makita XT286SM1 XRU11 Instruction Manual - Page 8

Press the check button on the battery cartridge to indicate the remaining battery capacity. The indicator lamps light up for few seconds. Indicator lamps Remaining capacity To start the tool, grasp the handle (the lock-off lever is released by the grasp) and then pull the switch trigger. To stop the tool, release the switch trigger. Lighted Off Blinking 1 75% to 100% 50% to 75% 25% to 50% 2 0% to 25% Charge the battery. The battery may have malfunctioned. NOTE: Depending on the conditions of use and the ambient temperature, the indication may differ slightly from the actual capacity. Power switch action ► 1 . Lock-off lever 2. Switch trigger NOTE: The tool is automatically turned off after the tool is left one minute without any operations. Speed adjusting You can adjust the tool speed by tapping the main power button. Each time you tap the main power button, the level of speed will change. WARNING: Before installing the battery cartridge on the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. Operating a tool with a switch that does not actuate properly can lead to loss of control and serious personal injury. CAUTION: Never put your finger on the switch when carrying. The tool may start unintentionally and cause injury. Press and hold the main power button for some seconds to turn on the tool. To turn off the tool, press and hold the main power button again. 1 ► 1 . Main power button Indicator Mode Auto Rotation speed 4,000 - 6,000 min-1 High 6,000 min-1 1 Medium 5,000 min-1 ► 1 . Main power button To prevent the switch trigger from being accidentally pulled, a lock-off lever is provided. 8 ENGLISH Low 4,000 min-1