Marantz PM-14S1 HDAM & Current feedback Amp of Marantz Unique technolo - Page 15

Preparation Connections Playback Stereo complete bi-amp connection This mode enables the two amplifiers connected to this unit to function as one monaural amplifier. To use this mode, two F.C.B.S. connected PM-14S1 units are required. To switch the mode, use the amplifier mode switch on the rear panel while the power is off. Super Audio CD player, etc. ENGLISH F.C.B.S. connection : Signal flow The figures below show example displays in the stereo and bi-amp modes. Stereo mode Bi-amp mode R L BBi-ia-ammppmmodoediendinicdaitcoar tor In bi-amp mode, connect to the left channel input jack. The right channel input is disabled. The same signals are output from the left and right output jacks. NOTE • Always turn the power to the unit off before changing the operating mode switch setting. Turning the power on again activates the new setting. • When in bi-amp mode, the R channel input jacks cannot be used. • When in bi-amp mode, the signals input into the L channel are output from both channels. Therefore, the same signals are output from the L channel and R channel in RECORDER OUT, PRE OUT, PHONES OUT. • Speaker systems connected using complete bi-amp connections must support bi-amp connections. Before connecting your speakers, check in the owner's manual that came with the speakers or contact the manufacturer to confirm whether they support bi-amp connection. • Set SPEAKER button on front panel in on position. • Set to "BI-AMP". Set SPEAKER button on front panel in on position. • Set to "BI-AMP". L R Set PM-14S1 for L channel to ID 1. MF / HF To power outlet. Set PM-14S1 for R channel to ID 2. MF / HF To power outlet. LF Remove shorting bar. L channel speaker Remove shorting bar. LF Remove R channel shorting bar. speaker Remove shorting bar. Settings Tips Appendix 11