Marantz PM5005 PM5005 Owner Manual In English - Page 36

Contents Connections Playback Settings Tips Appendix Troubleshooting 1. Are the connections correct? 2. Is the set being operated as described in the owner's manual? 3. Are the other devices operating properly? If this unit does not operate properly, check the corresponding symptoms in this section. If none of the symptoms are applicable, consult your dealer as it could be due to a fault in this unit. In this case, disconnect the power immediately and contact the store where you purchased this unit. o Power does not turn on / Power is turned off Symptom Cause / Solution Power is not turned on. 0 Check whether the power plug is correctly inserted into the power outlet. Power automatically turns off. 0 The Auto Standby mode is on. When approx. 30 minutes pass with no audio input and no operations on the unit, this unit automatically enters the standby mode. To turn off the Auto Standby mode, press the SOURCE DIRECT button for 5 seconds or longer. Power turns off and the power indicator flashes in red approx. every 0.25 seconds. 0 The protection circuit has been activated due to a rise in temperature within this unit. Turn the power off, wait about an hour until this unit cools down sufficiently, and then turn the power on again. 0 Please re-install this unit in a place having good ventilation. 0 Check the speaker connections. The protection circuit may have been activated because speaker cable core wires came in contact with each other or a core wire was disconnected from the connector and came in contact with the rear panel of this unit. After unplugging the power cord, take corrective action such as firmly re-twisting the core wire or taking care of the connector, and then reconnect the wire. 0 Turn down the volume and turn on the power again. 0 This unit's amplifier circuit has failed. Unplug the power cord and contact our customer service center. Page 23 30 40 － 17 25 － Front panel Rear panel Remote control 36 unit Index