Marantz RC1200 User Guide - Page 30

Using the Clone Mode

Get Marantz RC1200 PDF manuals and user guides View all Marantz RC1200 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 30 highlights

ENGLISH USING THE CLONE MODE All the codes which have been programmed can be copied altogether into another RC1200 remote controller by a few simple operations. (Macros and the set-up contents will also be copied.) Note: The clone function cannot be used for copying unless the same model (RC1200) is used for the remote controllers at the sending and receiving ends. 1. Place the light sensor (in the head section) of the remote controller at the receiving end about 5 centimeters (2 inches) away from and directly in front of the transmitter (also in the head section) of the remote controller at the sending end. MODE OFF ON MACRO LEARNING REMOTE CONTROL RC 1200 LEARNING REMOTE CONTROL RC 1200 POWER SOURCE ON / OFF POWER SOURCE ON / OFF MACRO O N OFF MODE 5cm 2. Use a ballpoint pen or other sharp point to press the MODE button z on the sending unit to call up the CLONE and TX displays. CLONE appears at LCD A and TX at LCD B. POWER SOURCE ON ON / OFF OFF LEARNING REMOTE CONTROL RC 1200 MACRO MODE 

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
29
ENGLISH
ON
OFF
ON / OFF
SOURCE
MACRO
MODE
LEARNING
REMOTE
CONTROL
RC
1200
POWER
ON
OFF
ON / OFF
SOURCE
MACRO
MODE
LEARNING
REMOTE
CONTROL
RC
1200
POWER
5cm
ON
OFF
ON / OFF
SOURCE
MACRO
MODE
LEARNING
REMOTE
CONTROL
RC
1200
POWER
USING THE CLONE MODE
All the codes which have been programmed
can be copied altogether into another RC1200
remote controller by a few simple operations.
(Macros and the set-up contents will also be
copied.)
Note:
The clone function cannot be used for
copying unless the same model (RC1200)
is used for the remote controllers at the
sending and receiving ends.
1.
Place the light sensor (in the head section)
of the remote controller at the receiving
end about 5 centimeters (2 inches)
away
from and directly in front of the transmitter
(also in the head section) of the remote
controller at the sending end.
2.
Use a ballpoint pen or other sharp point to
press the
MODE
button
z
on the sending
unit to call up the
CLONE
and
TX
displays.
CLONE
appears at LCD
A
and
TX
at LCD
B
.